Beurer BC 30 Manual De Instrucciones página 25

• The cuff must be fitted tightly around the wrist, but
must not constrict.
Blood pressure may vary between the right and left wrist,
which may mean that the measured blood pressure val-
ues are different. Always perform the measurement on
the same wrist.
If the values between the two wrists are significantly dif-
ferent, please consult your doctor to determine which
wrist should be used for the measurement.
Adopt the correct posture
• Before the initial blood pressure measurement, make
sure always to rest for about 5 minutes. Otherwise de-
viations can occur.
• You can perform the measure-
ment while sitting or lying. To car-
ry out a blood pressure measure-
ment, make sure you are sitting
comfortably with your arms and
back leaning on something. Do
not cross your legs. Place your
feet flat on the ground. Make sure to rest your arm and
move it. Always make sure that the cuff is at heart le-
vel. Otherwise significant deviations can occur. Relax
your arm and the palm of your hand.
• To avoid falsifying the measurement, it is important to
remain still during the measurement and not to speak!
Selecting memory
Press the button to display the date/time and current
user memory. Select the desired user memory by press-
ing the user selection button
with the button.
You have 2 memories with 60 memory spaces each to
store the measurements of 2 different people separate-
ly or to separate measurements taken in the morning
and at night.
Performing the blood pressure measurement
• As described above, attach the cuff and adopt the
posture in which you want to perform the measure-
ment.
• Select the user memory
ment by holding the
check, during which all numbers appear, the cuff in-
flates automatically. Whilst the cuff is pumping up, the
device already calculates measurements for estimating
the necessary pump pressure. If this pressure is insuf-
ficient, the device automatically pumps more pressure.
• Then the pressure in the cuff is slowly released and
the pulse is detected.
25
. Confirm your selection
or . Start the measure-
button. Following the display