Noise And Vibration Information; Preparations At The Workplace - Hilti SFD 22-A Manual De Instrucciones

4.2 Noise and vibration information

Sound power level L
WA
Screwdriving without hammer action a
Uncertainty for screwdriving without hammer action (K)
Drilling in metal a
h,D
Uncertainty for screwdriving without hammer action
drilling in metal (K)
5 Operation

5.1 Preparations at the workplace

CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Remove the battery before making any adjustments to the power tool or before changing
accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1.1 Inserting the battery
1. Push the battery into the battery holder until it engages with an audible click.
2. Check that the battery is seated securely.
5.1.2 Removing the battery
1. Press the release buttons on the battery.
2. Pull the battery out toward the rear.
5.1.3 Fitting the accessory tool
Note
The power tool has a 1/4" hex socket with locking sleeve as a chuck for various accessory tools.
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Push the locking sleeve on the hex socket forward.
◁ Hold the locking sleeve in this position.
3. Push the accessory tool into the chuck as far as it will go and release the locking sleeve.
4. Check that the accessory tool is held securely.
5.1.4 Removing the accessory tool
CAUTION
Risk of injury. The accessory tool may be hot or have sharp edges.
▶ Wear protective gloves when using the power tool and when changing accessory tools.
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Push the locking sleeve on the hex socket forward.
◁ Hold the locking sleeve in this position.
3. Pull the accessory tool out of the chuck and release the locking sleeve.
Printed: 08.06.2017 | Doc-Nr: PUB / 5356121 / 000 / 00
h
2
3
4
4
SFD -22A
80 dB
1 m/s²
1.5 m/s²
21 m/s²
1.5 m/s²
English 13