Sharing The Ios Device Setting - Yamaha NX-N500 Manual De Instrucciones

■ Connecting to the network using a
cable
As a default, this unit will automatically make a network
connection when it is connected to a wired router and turned
on.
• When connecting to the network using a cable, a network connection will
be established regardless of whether the WIRELESS switch on the rear
panel is set to "AUTO" or "OFF".
• If a wireless connection has already been established with this unit, the
WIRELESS switch on the unit must first be set to "OFF". After turning off
the unit and connecting the network cable, set the WIRELESS switch to
"OFF", and then turn the unit on again. In order to use Bluetooth, turn on
the unit before setting the WIRELESS switch to "AUTO".
1
Make sure that this unit is connected to the
router with a cable.
2
Press z (power) on the remote control to turn
on the unit.
The network settings are automatically specified. While
the settings are being specified, the status indicator on
the front panel flashes in green.
Left speaker (front panel)
When the connection is established, the status indicator
on the front panel changes to lit.
Left speaker (front panel)

■ Sharing the iOS device setting

You can easily setup a wireless connection by applying the
connection settings on iOS devices (iPhone/iPod touch).
Before proceeding, confirm that your iOS device is connected
to a wireless router (access point).
• In order to share Wi-Fi settings, the iOS device must be installed with iOS
7 or later.
• Following the procedure below will reset specified account information
and registered preset settings.
• If network settings have already been specified, reset the network
connection, and then follow the procedure below.
• If a wired connection has already been established with this unit, the
WIRELESS switch on the unit must first be set to "OFF" while the unit is
on. After disconnecting the network cable, set the WIRELESS switch to
"AUTO".
1
Set the WIRELESS switch on the rear panel to
"AUTO".
Left speaker (rear panel)
Green (flashing)
2
Press z (power) on the remote control to turn
on the unit.
The status indicator on the front panel flashes in pink.
Left speaker (front panel)
Green (lit)
When this unit detects an iOS device, a connection
confirmation message appears.
3
Tap "Allow" in the iOS device screen.
When the connection is established, the status indicator
on the front panel lights up in green.
Left speaker (front panel)
R CH
AUDIO OUT
AUTO
WIRELESS
OFF
CONNECT
WIRELESS
DIRECT
SOURCE
AC IN
GAIN
MIN MAX
WIRELESS switch
Pink (flashing)
Green (lit)
15
En