GBC SureBind 500 Manual De Instrucciones página 5

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
Cleaning
m
Caution: Unplug this product before cleaning it.
• Wipe exterior only with a damp cloth. Do not use detergents
or solvents.
• Do NOT use aerosol dusters or cleaners.
• Do NOT spray anything into the machine.
• Foreign substances can be explosive.
Symbols
Power On
Setting up
Retain the packaging in case you need to return the machine for
1
repair. Place on a secure, stable surface.
2
The machine is divided into two parts, one for punching and one for
binding. This means that one person can be punching while another
person is binding.
Document assembly
Collate your punched document and check all holes are aligned
1
correctly.
2
Place the receiving strip (bottom binding strip with holes) textured
side down onto the machine (see fig 1). Be sure that the locating
hole, (smaller than the rest of the holes) in the receiving strip is
placed over the locating pin (see fig 2). The strip is positioned
correctly over the locating pin when it is difficult to slide the
strip to the right. Failure to properly align the strip can cause
damage to the machine.
Place the back cover (face down), the punched sheets (with the
3
last page on the bottom) and the front cover (face up) on top of the
receiving strip.
Insert the pins of the correct size document strip through the
4
punched holes (see fig 3) so that the pins of the document strip go
into the holes in the receiving strip (see fig 4).
Guarantee
Operation of this product is guaranteed for 2 years, from date of
purchase, subject to normal use. Within the guarantee period, ACCO
Brands Europe will at its own discretion repair or replace the defective
machine free of charge. Defects due to misuse or use for inappropriate
purposes are not covered under the guarantee. Proof of date of
Register this product online at www.accoeurope.com
Binding the document
Place your hands at both the right and the left end of the pressure
1
bar (pressing on only one side or in the middle will cause binding
quality problems). Press the bar downwards with an even force. (see
fig 5).
2
Next, pull the welding and cutting handle down towards you. The
machine will weld and cut in about 10-20 seconds and the indicator
light will turn off.
Please Note: Once the bar is place downwards please do not
continue to push/hold the handle during the cutting and melting
process. This will result in an unsatisfactory closure of the
document.
Press the pressure bar release buttons (see fig 6) on both sides of
3
Power Off
the machine. The pressure bar will pop upwards. Lift up the welding
and cutting handle. (see fig 7).
Remove the bound document.
4
Important: Please make sure the pressure bar is rotated to a
downwards direction for smaller documents. Failure to do this will
result in an unsatisfactory closing of the document (see fig 9).
Waste trays
• The waste tray covers are located on both sides of the machine.
Remove the covers and empty the contents of the waste trays on a
regular basis, to prevent clogging and possible damage (see fig 8).
Important: The waste tray on the binding unit is provided with a
safety switch. If the waste bin is not properly replaced back into the
unit, the ready lamp on the machine will not light up and the binding
machine cannot be used.
purchase will be required. Repairs or alterations made by persons not
authorised by ACCO Brands Europe will invalidate the guarantee. It is
our aim to ensure that our products perform to the specifications stated.
This guarantee does not affect the legal rights which consumers have
under applicable national legislation governing the sale of goods.
G

Tabla de contenido
loading

Tabla de contenido