Installation In Harness Mode; Important - Britax GROW WITH YOU CLICKTIGHT Guia Del Usuario

Britax Child Safety, Inc.

Installation in Harness Mode

Lap-Shoulder Belt with CLICKTIGHT (Preferred Method)
Before you begin:
• Check that your vehicle has a top tether anchor�
Britax recommends that the top tether be used at all
times when installing the child seat� Using the top
tether will improve the stability of your child seat and
reduce the risk of injury� Check your vehicle owner's
manual for tether anchor locations�
• Loosen the tether and place it over the child seat
back to keep it from becoming pinned between the
child seat and vehicle seat during installation�
• Adjust the child seat to desired position and place
forward facing on the vehicle seat�
1� Release the buckle and
open the CLICKTIGHT�
a� Locate the two slots
in the CLICKTIGHT
cover�
b� Squeeze the
CLICKTIGHT release
levers�
2� Pull the vehicle belt out
and route along the green
belt path� Verify that the
belt is not twisted and then
buckle�
3� Remove slack from the lap
part (a), then shoulder part
(b) of the vehicle belt�

IMPORTANT:

Overtightening the
belt may prevent the
CLICKTIGHT from properly
securing�
4� Close the CLICKTIGHT� A click confirms the
CLICKTIGHT is secure�
NOTE: The child seat is
secure when it cannot be
moved front-to-back or
side-to-side more than
1 in. (2.5 cm) at the belt
path. If the child seat is
not secure, repeat the
installation procedure or use a different seating location.
10