Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Configuration
(Standalone)
Sound Mode
Sound Sensitivity
Auto Modes
Master/Slave
Mode
Page 18 of 64
Set the product in one of the standalone modes to control without a DMX controller.
1.
Connect the product to a suitable power outlet.
2.
Turn the product on.
Never connect a product that is operating in any standalone mode (Static, Auto, or
Sound) to a DMX string connected to a DMX controller. Products in standalone
mode may transmit DMX signals that could interfere with the DMX signals from
the controller.
To enable the Sound-Active program, do the following:
1.
Press <FUNC> repeatedly until Sou blinks on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select the desired color(s).
4.
Press <ENTER> and the SOUND indicator light turns on.
To set the sound sensitivity, follow the instructions below:
1.
Press <FUNC> repeatedly until S 0—S 9 blinks on the display.
2.
Use <UP> or <DOWN> to select the desired sound sensitivity.
3.
Press <ENTER>.
·
The product will only respond to low frequencies of music (bass and drums).
·
The laser will blackout when in Sound mode after 3 seconds of silence or
noise below the sensitivity setting.
To enable the auto programs, follow the instructions below:
1.
Press <FUNC> repeatedly until AuF (fast auto program) or
AuS (slow auto program) blinks on the display.
2.
Press <ENTER> to select the desired auto program.
3.
Use <UP> or <DOWN> to select the desired color(s).
4.
Press <ENTER>.
The Master/Slave mode allows a single Scorpion™ Storm FX RGB product (the master)
to control the actions of one or more Scorpion™ Storm FX RGB products (the slaves)
without the need of a DMX controller. The master will be set to operate in either an auto
program or Sound mode, while the slaves will be set to operate in Slave mode. Once set
and connected, the slave units will operate in unison with the master unit.
Configure the units as indicated below.
Slave units:
1.
Press <FUNC> repeatedly until SLA shows on the display.
2.
Press <ENTER>.
3.
Connect the DMX input of the first slave unit to the DMX output of the master unit.
4.
Connect the DMX input of the subsequent slave units to the DMX output of the
previous slave unit.
5.
Finish setting and connecting all the slave units.
Master unit:
1.
Set the master unit to operate in either an auto program or Sound mode.
2.
Make the master unit the first unit in the DMX daisy chain.
·
Configure all the slave units before connecting the master unit to the DMX
daisy chain.
·
Never connect a DMX controller to a DMX string configured for Master/Slave
operation because the controller may interfere with the signals from the
master unit.
·
Do not connect more than 31 slave units to the master unit.
Scorpion™ Storm FX RGB User Manual Rev. 3
Tabla de contenido
