How To Use The Device; How To Insert Batteries; How To Connect The Electrode Cord - Omron E2 ELITE Manual De Instrucciones

Neuroestimulador electrónico
Ocultar thumbs Ver también para E2 ELITE:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 66
HV-F127 manual.book Page 8 Monday, December 29, 2014 3:34 PM

2.How to use the device

2. How to use the device

2.1 How to insert batteries

Turn the Intensity Adjustment Dial/Power Switch to the
1.
"OFF" position.
Open battery cover on the back of the
2.
main unit.
Insert batteries according to the
3.
polarities (+ and -) shown in the bat-
tery compartment.
Close the battery cover.
4.

2.2 How to connect the electrode cord

Turn the Intensity Adjustment Dial/
1.
Power Switch to the " " position.
Insert the Electrode Cord Plug into
2.
the Electrode Cord Jack on the
main unit.
Connect the Electrode Cord to the
3.
Long Life Pads.
Place the Pads on a flat surface
and securely connect the Elec-
trode Cord Plugs to the Pads.
* Although Electrode Cord Plugs
are provided in red and white,
either plug can be connected
with one of the Pads irrespec-
tive of color.
8
General advice from OMRON on the handling of batteries
• The supplied batteries are for the trial use only and may
wear out in less than three months.
• Replace the worn batteries with new ones immediately.
• If you are not going to use the unit for more than three
months, remove the batteries.
• If you leave the unit without using it for a long time when
the batteries are included inside, leakage from the batter-
ies may occur.
• Do not use new and worn batteries together or different
types of batteries together.
• Insert the batteries with the polarities (+ and –) in correct
alignment.
SIZU'AAA'
1.5V LR03
OOOOOO
• When handling the batteries, be sure to read the notes
SIZU'AAA'
1.5V LR03
OOOOOO
on the batteries.
• Dispose of the used batteries according to the applicable
local regulations.
Standard for battery replacement
If you feel the massage stimulation is weak, the batter-
ies may be worn. Replace the batteries with new ones.
When using the unit for the first time
Take out the Pads from the clear plastic bag.
* Do not peel off the clear film attached to the Pad at this
time.
General advice from OMRON on the handling of Electrode Cord
• Avoid excessive bending and pulling of the Electrode
Cord.
• Hold the Electrode Cord Plug when unplugging the Elec-
trode Cord from the Main Unit.
• If the Electrode Cord is torn or has a problem, please
contact the store where you purchased the unit or at the
nearest OMRON dealer.
Tabla de contenido
loading

Este manual también es adecuado para:

Hv-f127-e

Tabla de contenido