Troubleshooting - Omron E2 ELITE Manual De Instrucciones

HV-F127 manual.book Page 15 Monday, December 29, 2014 3:34 PM

3.3 Troubleshooting

Problem
 The power cannot  The batteries are wrongly inserted.
be switched on.
 The pads are not properly attached to the
skin.
 The power switches  The pads are removed from the skin·
off to soon.
 The power switches  The batteries are worn out or empty.
off while the unit is
in use.  The power turns automatically off after
15 minutes.
 The electrode cord is broken.
 The clear film on the adhesive surface of
the pad has not been removed.
 The adhesive surface of the pad is dirty.
 The pads do not
 The pads are used directly after washing
attach to the skin.
them.
 The adhesive surface of the pads is
damaged.
 The pads may have been used while
perspiring.
 The pads may have been washed too long
and too frequently.
 The pads may have been stored under
high humidity, high temperature or in direct
sunshine.
 The pads are not in close contact with the
 The stimulating skin.
effect cannot be felt.  The pads are attached, but overlapping
each other.
 The electrode cord is not connected
properly.
 The intensity is at a too low level.
 The batteries are worn out or empty.
 The adhesive surface of the pads is
damaged.
 The treatment has continued too long.
 The pads are not in close contact with the
 The skin turns red.
skin.
 The skin feels
 The adhesive surface of the pads is dirty or
irritated.
dry.
The adhesive surface of the pads is

damaged.
* If the unit does not operate after taking the above-mentioned measures, contact the nearest OMRON dealer.
Cause
⇒ Insert the batteries according given directions.
⇒ Reattach the pads securely to the skin. (Otherwise
power will switch off automatically).
⇒ Switch off the unit before removing the pads from the
skin.
⇒ Replace with new batteries, following given
directions.
⇒ Replace the electrode cord with a new one.
⇒ Remove the film.
⇒ Clean the pads, following given directions.
⇒ After washing, allow the pads sufficient time for
drying.
⇒ Replace the pads with new ones.
⇒ Leave the pads in a refrigerator overnight.
⇒ Reattach the pads to the skin properly.
⇒ Reattach the pads to the skin while assuring they do
not overlap.
⇒ Connect the electrode cord properly.
⇒ Increase the intensity.
⇒ Replace the batteries with new ones, following
direction given.
⇒ Replace the pads with new ones.
⇒ Limit the treatment time to the programmed
15 minutes.
⇒ Reattach the pads to skin properly.
⇒ Wash the pads, following given directions.
⇒ Replace the pads with new ones.
3.Maintenance
Remedial Action
EN
15