Connection Diagram; User Interface; Nvr Access - Velleman NVR3 Guía Rápida

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

Rear panel
Connect to a storage device that supports the eSATA interface. For example, an external hard
disk or a disk array.
eSATA
Note: Make sure that the disk array supports Linux® to ensure proper functioning.
Connect to a monitor that supports high-definition video output (HDMI port).
HDMI
Note: Use an appropriate adapter (not incl.) to connect a monitor with VGA or composite
connectors.
INTERNET
Connect to internet via an 8P8C network cable.
(WAN)
Connect to local IP cameras via an 8P8C network cable. The LAN ports support PoE (Power over
1 – 4 (LAN)
Ethernet), therefore no power adapters are required for the cameras.
On/off switch. Set to I to switch the NVR on. Set to O to switch off.
DC48V IN
Connect to the power supply adapter (incl.).
7.

Connection Diagram

Refer to the illustrations on page 2 of this manual.
Note: This configuration method applies to ETS cameras.
The NVR will automatically configure the IP address of an ETS camera connected by LAN if:
The default IP configuration method of the camera is DHCP.
The camera is powered on before the NVR is powered on.
You can connect up to 4 IP cameras.
A
IP camera
Alarm I/O + magnetic contact. Refer to the user
B
manual of the IP camera for connection.
C
8P8C network cable
D
remote control
E
on/off switch
Connecting the IP Camera (Plug and Play)
1. Connect the camera to a LAN port. Make sure the camera is switched on.
2. Switch on [E] the NVR.
3. Wait until the camera is configured automatically and the images appear on the monitor.
8.

User Interface

8.1

NVR Access

1. Connect a USB mouse (included) to the mouse port  on the NVR front panel, and check if there is a
mouse icon
on the screen, indicating the USB mouse is detected properly.
2. Move your mouse to enter the DVR password with the password keypad. The default user name and
password are both admin.
The status will change from
Note: You can configure four different user levels with different access privileges in the main menu
(SYSTEM) > ACCOUNT. For more information, refer to the full user manual on the included CD-ROM.
V. 01 – 07/08/2013
NVR3
(key lock) to
(unlock).
5
Install a HDD in the NVR before connecting it to
F
the IP cameras.
G
external hard disk or disk array (eSATA)
H
HDMI monitor
IP camera, laptop, iPhone, iPad, Android device,
I
etc. via internet
J
48 VDC power adapter
©Velleman nv
Tabla de contenido
loading

Tabla de contenido