Maytag EPIC z Manual De Uso Y Cuidado página 24

Cleaning the exterior
Use a soft damp cloth or sponge to wipe up ally spills. Occasionally wipe tile outside of your
washer to keep it looking new. Use mild soap and water. Do not use abrasive products.
Cleaning the dispenser drawer
The dispenser drawer can be removed for easy cleaning.
1. Unlock the dispenser drawer by pressing the Release ].even See "Using the Dispenser."
Remove the drawer.
2. Remove the inserts (the siphon from the softener and bleach compartments).
3. Wash the parts under running water.
NOTE: Do not wash components in the dishwasher.
4. Replace the inserts and return the dispenser to the drawer.
Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Periodically inspect
and replace inlet hoses if bulges, kinks, cuts, wear or leaks are found.
When replacing your inlet hoses, record the date of replacement.
Install and store your washer where it will not freeze. Because some water may stay in the
hoses, freezing can damage your washer. If storing or moving your washer during freezing
weather, winterize it.
Non-use or vacation care:
Operate your washer only when you are at home. If you will be on vacation or not using your
washer for an extended period of time, you should:
• Unplug washer or disconnect power.
• [urn off the water supply to the washer. This helps avoid flooding (due to a water pressure
surge) while you are away.
• Slightly open door to provide ventilation.
To winterize washer:
1. Put 1 qt (1 1.) of R.V.-type antifreeze in the drum.
2. Run washer on a Drain & Spin cycle.
3. Unplug washer or disconnect power.
4. Shut off both water faucets.
5. Disconnect water inlet hoses from faucets and drain.
To use washer again:
1. Flush water pipes.
2. Reconnect water inlet hoses to faucets.
3. Turn on both water faucets.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong:
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock:
4_
5.
Plug in washer or reconnect power.
Run the washer through the Normal cycle with _/2the manufacturer's recommended
amount of HE detergent for a medium-size load, to clean the washer and remove the
antifreeze, if used.
To transport the washer:
1. If washer will be moved during freezing weather, put in 1 qt (1 1) of R.V.-type antifreeze in
the drum. Run washer on a Drain & Spin cycle.
2. Unplug the power cord.
3. Disconnect the drain hose from the drain system and attach to rear panel clips.
4. Shut off both water faucets.
5. Disconnect the water inlet hoses from faucets, then drain the hoses and clip them to the
rear panel of the washer.
6. IMPORTANT: Call service. Do not reuse transport bolts. Washer must be transported in
the upright position. Ib avoid suspension and structural damage, your machine must be
properly set up for relocation by a certified technician.
Reinstalling the washer
2.
Follow the "installation Instructions" to locate, level and connect the washer.
Run the washer through the Normal cycle with _/2the manufacturer's recommended
amount of HE detergent for a medium-size load, to clean the washer and remove the
antifreeze, if used.
2 4