Tabla de contenido
Idiomas disponibles
Idiomas disponibles
DWS-150-IB SP\ENG
10/12/04
11:30 AM
Table Top -
For the home receiver, fold out the base on the back of the
unit and snap into place. For the remote sensor, simply pull
out the integrated stand from the bottom.
Wall Mounting -
For the home receiver - Snap stand in upright position. Set a
screw (not included) into the desired wall and place unit onto
the screw using the back side hanging hole.
For the remote sensor - Set a screw into the desired
hanging location and mount.
MAINTENANCE AND CARE
INSTRUCTIONS
• Extreme temperatures, shock or areas of unusual vibration
should be avoided to prevent damage to the units.
• Clean the units using only a soft, damp cloth to wipe.
Do not use solvents, abrasives, detergents or other strong
cleaning agents. After cleaning, wipe surfaces with a dry
cloth.
• Do not submerge units in water or other liquids.
• Do not subject the units to extremely severe temperatures
- DO NOT PLACE UNITS INTO OVENS, FREEZERS or
MICROWAVE OVENS.
NOTES
• Opening the housing of either the remote sensor or the
home receiver will invalidate your warranty. Do not
attempt to repair this unit. There are no consumer
serviceable parts.
• If you encounter any difficulties in setting up your wireless
thermometer system, please contact Consumer Relations.
• Your new RF Thermometer is built with random security
Page 7
6
code technology. The home receiver will learn the random code of the first
remote sensor and log it in as channel 1. Channel 2 and Channel 3 will
be registered in the same way if additional sensors are used. The home
receiver can monitor up to 3 separate sensors.
• Once a channel is registered, it will not accept any new sensors. However,
registered channels can be erased by removing the batteries in the
remote sensor or the home unit.
• When replacing batteries for the remote sensor - Remember to clear the
corresponding channel of the home receiver by removing the batteries
–OR– Select the respective channel of the sensor by pressing the
CHANNEL button on the home receiver. Hold the CHANNEL button for 3
seconds to clear the registration.
• When replacing batteries for the home receiver - Please remove the bat-
teries of all remote sensors. Once you have replaced the home receiver
batteries, re-install the batteries to the sensors according to the desired
channel sequence. This will ensure that the home receiver and the
remote sensors are properly synchronized.
• Press the Tx button on the back of remote sensor to verify the RF reception.
• It is recommended to test the home receiver and the remote sensor next
to each other to ensure that both are properly synchronized.
• Keep the remote sensor out of direct sunlight and rain. Do not mount
on a metal surface.
About the Atomic Clock
The National Institute of Standard and Technology (NIST) in Fort Collins,
Colorado broadcasts the time signal (WWVB at 60kHz AM radio signal) with
an accuracy of 1 second per every 3,000 years. The signal will cover a
distance up to 2,000 miles from the source. Like a typical AM radio, your
Atomic Clock will not able to receive the WWVB signal in places
surrounded by heavy concrete or metal panels. The reception of the time
signal can be affected by mobile phones, TV, electrical appliances or other
electronic interference. To get the best performance of the Atomic clock,
please install the home receiver near a window and away from large metallic
objects. If the unit is not working properly, change the unit position. There
may be some interference at this location.
7
Tabla de contenido
