Tabla de contenido
Idiomas disponibles
Idiomas disponibles
DWS-130SP-ENG.qxd
10/12/04
11:36 AM
TEMPERATURE TREND INDICATOR:
In the upper left hand corner of the home receiver LCD display,
you will see one of 3 icons;
will indicate Rising Temperature readings if it changes
more than 1 degree in an hour
will indicate Steady Temperature readings
will indicate Falling Temperatures if it is more than
1 degree in an hour.
TEMPERATURE ALERT
Press "ALERT" to turn temperature alert on and off.
1. Hold "ALERT" button located on back of home receiver for
3 seconds to enter the alert setting mode. The indoor icon
will flash.
2. Press " +, - " to select the between indoor temperature or
outdoor temperature to be alerted to. Press "ALERT" to
confirm your selection. The Upper pointer and the value on
the LCD display will flash. Enter the desired upper limit with
the " +, - " buttons, press "ALERT" to confirm your
selection and then go to the lower limit setting.
3. The Lower pointer and value will flash. Enter the desired
lower limit with " +, - " buttons. Press "ALERT" to confirm
and exit.
4. You may enter an alert setting for the indoor temperature
and remote sensor temperature.
5. When the temperature hits the limit of your preset levels,
the Upper/Lower pointers and the temperature of the
respective channel (indoor or remote sensor) will flash and
produce an audible alarm. Press any button on the home
receiver to acknowledge and stop the alarm.
6. To turn alert off, press "ALERT" button. The "
should not be shown.
Page 5
" icons
4
LOW BATTERY INDICATION
Low battery indication is available for the home receiver and
the remote sensor. "LO" will be displayed on the remote
sensor and a battery life "
" icon will be shown on the
home receiver. Replace the batteries as necessary and follow
the setup procedure as mentioned earlier in the "GETTING
STARTED" section.
MOUNTING INSTRUCTIONS
Table Top -
For the home receiver and the remote sensor, simply pull out
the integrated stand from the bottom.
Wall Mount -
For remote sensor and home receiver - Set a screw into the
desired hanging location and mount.
MAINTENANCE AND CARE
INSTRUCTIONS
• Extreme temperatures, shock or areas of unusual vibration
should be avoided to prevent damage to the units.
• Clean the units using only a soft, damp cloth to wipe.
Do not use solvents, abrasives, detergents or other strong
cleaning agents. After cleaning, wipe surfaces with a
dry cloth.
• Do not submerge units in water or other liquids.
• Do not subject the units to extremely severe temperatures
- DO NOT PLACE UNITS INTO OVENS, FREEZERS or
MICROWAVE OVENS.
5
Tabla de contenido
