Tabla de contenido
Idiomas disponibles
Idiomas disponibles
DWS-220SP-ENG.qxd
10/12/04
11:34 AM
LOW BATTERY INDICATION
Low battery indication is available for the home receiver
and the remote sensor. "LO" will be displayed on the
remote sensor and a battery life "
on the home receiver. Replace the batteries as necessary
and follow the setup procedure as mentioned earlier in the
"GETTING STARTED" section.
MOUNTING INSTRUCTIONS
Table Top -
For the home receiver, fold the base down and into the back
of the unit. For the remote sensor, simply pull out the inte-
grated stand from the bottom.
Wall Mount -
For the remote sensor - Set a screw into the desired
hanging location and mount.
For Home Receiver -
Pull base out and fold up onto mounting pegs. (Base will
snap into place). Set a screw into the wall and mount.
MAINTENANCE AND CARE
INSTRUCTIONS
• Extreme temperatures, shock or areas of unusual vibration
should be avoided to prevent damage to the units.
• Clean the units using only a soft, damp cloth to wipe.
Do not use solvents, abrasives, detergents or other strong
cleaning agents. After cleaning, wipe surfaces with a
dry cloth.
• Do not submerge units in water or other liquids.
• Do not subject the units to extremely severe temperatures
- DO NOT PLACE UNITS INTO OVENS, FREEZERS or
MICROWAVE OVENS.
Page 7
" icon will be shown
6
NOTES
• Opening the housing of either the remote sensor or the home receiver will
invalidate your warranty. Do not attempt to repair this unit. There are no
consumer serviceable parts.
• If you encounter any difficulties in setting up your wireless thermometer
system, please contact Consumer Relations.
• Your new RF Thermometer is built with random security code technology.
The home receiver will learn the random code of the first remote sensor
and log it in as channel 1. Channel 2 and Channel 3 will be registered in
the same way if additional sensors are used. The home receiver can
monitor up to 3 separate sensors.
• Once a channel is registered, it will not accept any new sensors. However,
registered channels can be erased by removing the batteries in the
remote sensor or the home unit.
• When replacing batteries for the remote sensor - Remember to clear the
corresponding channel of the home receiver by removing the batteries or
select the respective channel of the sensor by pressing the CHANNEL
button on the home receiver. Hold the CHANNEL button for 3 seconds to
clear the registration.
• When replacing batteries for the home receiver - Please remove the
batteries of all remote sensors. Once you have replaced the home
receiver batteries, re-install the batteries to the sensors according to the
desired channel sequence. This will ensure that the home receiver and
the remote sensors are properly synchronized.
• Press the Tx button on the back of remote sensor to verify the RF reception.
• It is recommended to test the home receiver and the remote sensor next
to each other to ensure that both are properly synchronized.
• Keep the remote sensor out of direct sunlight and rain. Do not mount
on a metal surface.
About the Atomic Clock
The National Institute of Standard and Technology (NIST) in Fort Collins,
Colorado broadcasts the time signal (WWVB at 60kHz AM radio signal)
with an accuracy of 1 second per every 3,000 years. The signal will cover
a distance up to 2,000 miles from the source. Like a typical AM radio,
your Atomic Clock will not able to receive the WWVB signal in places
surrounded by heavy concrete or metal panels. The reception of the time
7
Tabla de contenido
