Removing The Blades (Fig. A, E1-E4); Replacing The Blades (Fig. E2-E5) - DeWalt DW733 Manual De Instrucciones

Fig. E5
27
Removing the Blades (Fig. A, E1–E4)
1. Unlock the head lock lever
2. Adjust the depth of cut to approx. 75 mm.
3. Remove the two hex screws
remove the dust adaptor
to expose the blades.
4. Carefully rotate the cutterhead
blade becomes visible.
5. Lock the head lock lever
6. Loosen the seven blade clamping screws
(Fig. E2) using the wrench supplied.
7. Remove the blade from the cutterhead for
re-sharpening or replacement.
8. Press the cutterhead locking lever
slowly rotate the cutterhead until the other blade can
be removed.
Replacing the Blades (Fig. E2–E5)
1. Position the cutterhead
30
2. Place the blade in the cutterhead and ensure that the
head of the height adjustment screw
locates into the blade slot.
3. Loosen the seven screws
clamp against the blade a little bit to allow the blade to
be adjusted for height.
4. Place the gauge (Fig. E4) on the cutterhead as close
32
as possible to the height adjustment screw
still allowing movement of the hex key.
5. Turn one height adjustment screw
key until the blade tip touches the gauge
Repeat the procedure with the other height adjustment
screw. Check to ensure the blade height is even. Repeat
this procedure if needed.
6. Tighten the two end clamping screws
8.0 Nm.
7. Remove the gauge and tighten the five middle
clamping screws 26 (Fig. E2) to 8.0 Nm.
8. Press the cutterhead locking lever
slowly rotate the cutterhead until the other blade can
be replaced following the above procedure.
32
2 (Fig. A).
25 (Fig. E1) and carefully
and tool tray (Fig. A)
13 12
30 (Fig. E4) until the first
2 (Fig. A).
26 , 28
29 (Fig. E3) and
as shown in Figure E4.
27 (Fig. E4)
26 , 28 (Fig. E2) on the blade
27 while
27 with the hex
32 (Fig. E5).
28 (Fig. E2) to
(Fig. E3) and
29
OPERATION

WARNING: Always observe the safety instructions
and applicable regulations.

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Proper Hand Position (Fig. G)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal injury,
ALWAYS hold securely in anticipation of a sudden
reaction..
Fig. G
Switching On and Off (Fig. F1, F2)
The On/Off switch of your DW733 is equipped with a circuit
breaker. In case of motor overload, the power supply to the
motor will be cut off. If this happens, turn the machine off
and press the reset button 35
• The workpiece should not be in contact with the
cutterhead when switching on.
To turn on, pull the on/off switch
now works in continuous operation.
• Allow the motor to reach full speed before feeding
the workpiece.
• Allow the blades to cut freely. Do not force.
To switch off, press the on/off switch
To lock the machine off, insert a padlock into the hole

WARNING: Always turn off the tool when work is
finished and before unplugging.
Fig. F1
35
ENglIsh
(Fig. F1).
1 up (Fig. F2). The tool
1 down.
36 .
27