Important - Dea GEKO Instrucciones De Uso Y Advertencias

6 STANDARD PROGRAMMING
1
Power Supply
Give power supply, the display shows the following symbols "
*
If the control panel has already been programmed and the power fails or is switched off - once power is returned and a START
command is given, the position reset procedure is performed (see "rESP" in the table "WORKING STATUS MESSAGES" on page 24.
2
Visualisation of inputs and operations-counter status
1. Press the key for 15 seconds;
2. The display will show respectively:
Inputs status (check it's correct);
Total operations counter (* see P064):
i.g.: = 3x1000* = 3000 operations performed
Maintenance operations-counter (* see P065):
i.g.: = 5*x500 = 2500 operations remaining
before the maintenance intervention request (
manoeuvres-counter disabled)
3. Hold down the key to display a cyclic 3 options, or
release the button to exit the parameter.
3
Selection type of operators
1. Scroll down the parameters with
sualise P028;
2. Access the parameter by pressing the
3. Verify that the value corresponds to d000 (GEKO), otherwise,
you must select it by pressing
4. Confirm your choice by pressing the
again to P028).
4
Selection operating with or without encoder
Warning: Remember to correctly set the jumpers J5 and J9.
A A
A position = operators with encoder (remind to set P029=0)
B B
B position = operators without encoder (remind to set P029=1)
1. Scroll down the parameters with
sualise P029;
2. Access the parameter by pressing the
3. Acting on and keys, set:
- d000=for operators with encoder;
- d001=for operators without encoder;
4. Confirm your choice by pressing the
again to P029).
", "
=

! IMPORTANT !

and keys until you vi-
key;
and keys;
key (display returns
and keys until you vi-
key;
key (display returns
", " " and then "----".
! IMPORTANT !
19