Oase FiltoClear 3000 Instrucciones De Uso página 10

- English -
Cleaning the quartz glass tube manually
Attention! Ultra-violet radiation.
!
Possible consequences: Eye or skin injury from burns
Protective measures:
• Never operate the UVC lamp outside its housing.
• Never operate the UVC lamp in a housing that is defective
Danger: Ultraviolet radiation.
!
Do not expose eyes to lamp rays.
Disconnect power before servicing or replacing lamp.
Warning: To reduce the risk of electric shock - Connect only to a circuit that is protected by a ground-fault circuit
interrupter (GFCI)
For indoor and outdoor household use
Attention! Breakable glass
Possible consequences: Injury to your hands caused by cuts
Protective measures: Handle the quartz glass and UVC lamp with care.
• Switch off the filter pump and UVC unit.
• Remove the UVC unit head (See Cleaning and maintenance\Removing/inserting the UVC unit head).
• Check the quartz glass tube and O ring for damage. Replace, if necessary.
• Clean the quartz glass tube externally using a moist cloth.
• Insert the UVC unit head (See Cleaning and maintenance\Removing/inserting the UVC unit head).
• Switch on the filter pump.
• Switch on the UVC unit.
Attention! Dangerous electrical voltage.
Possible consequences: Death or serious injuries.
Protective measures: Switch off the mains voltage prior to carrying out work on the unit
Cleaning the unit and washing or replacing the foam filters
Wear of the foam filters is caused by mechanical stress and normal ageing. OASE recommend: Replace old foam filters
with new ones at the beginning of the new season.
• Switch off the filter pump.
A. Remove all hoses, hose connections.
• Remove the UVC unit head (See
Cleaning and maintenance\Removing/
inserting the UVC unit head).
• Open the container (See Cleaning and
maintenance\Opening the container).
Disassembling the foam filters
• Check the foam filters, and either
wash or replace.
B. Remove the filter disk (15) after
loosening and removing the two
screws (43).
C. Remove the lid including the stack
of foam filters (39).
• Place the foam filters on a soft
clean surface such that the
fixing disk (15) of the stack of
foam filters faces upward.
A
B
C
8