Installing/Removing Battery Pack; Installing/Removing Blades - Ubermann UJS04BRA Manual Del Operador

OPERATION
To turn the saw ON, depress the trigger lock button and pull the
switch trigger. Release the switch trigger to turn the saw OFF.
NOTE: The trigger lock button can be depressed from either side.
The trigger lock automatically resets when the switch trigger is
released.

Installing/Removing Battery Pack

See Figure 2, page 15.
To install:
• Insert the battery pack.
• Make sure the latches on each side of the battery pack snap
in place and that battery pack is secured in the product before
beginning operation.
To remove:
• Depress the latches on each side of the battery pack.
Splinter-Free Cutting
See Figure 3, page 15.
The anti-splintering insert is especially useful when cutting
plywood. It should only be used when making straight cuts or
circle cuts. It is not for bevel cutting or plunge cutting.
NOTE: The non-orbital setting also helps reduce splintering
when cutting plywood.
To attach and remove the anti-splintering insert:
• Remove the battery pack.
• Set the cutting angle at 0°.
• To attach, slide the insert back onto the tabs on the front of
the shoe. Make sure it snaps securely into place.
• To remove, grasp the anti-splintering insert and pull straight
out.
• Reinstall the battery pack.
Chip Shield
See Figure 4, page 15.
A clear plastic chip shield on the front of the saw helps protect
against flying dust and chips.
To remove and reattach the chip shield:
• Remove the battery pack.
• To remove, grasp and push in the sides of the chip shield as
shown. Pull out.
• To reattach, grasp and push in the sides of the chip shield as
shown. Slide it into the slots on each side of the front of the
saw.
• Reinstall the battery pack.

Installing/Removing Blades

See Figure 5, page 15.
The tool-free blade clamp does not require the use of a blade
wrench when installing or removing the blade.
NOTE: The jig saw is designed to use T-shank blades only.
To install blades:
• Remove the battery pack.
• Remove the chip shield and the anti-splintering insert if
needed.
• Pull the blade clamp out until it stops.
• Holding the blade clamp out, insert the saw blade as far as
possible into the slot in the saw bar. Some resistance may be
felt in doing this.
• Check to make sure the back of the saw blade is centered in
the groove of the blade-support roller.
• Release the blade clamp. Make sure the blade is securely in
place.
• Replace the chip shield and anti-splintering insert if needed.
• Reinstall the battery pack.
To remove blades:
• Remove the battery pack.
• Remove the chip shield and the anti-splintering insert if
needed.
• Pull the blade clamp out until it stops.
• Holding the blade clamp out, remove the saw blade.
• Reinstall the battery pack.
General Cutting
See Figure 6, page 15.
The no-mar plate has a smooth finish and can be snapped on
over the metal shoe of the jig saw. This makes it easier to glide
the tool along a delicate work surface without marring it.
9 — English