After Printing; Removing The Label Backing - Brother P-touch 9500PC Referencia Rápida

After printing

This section contains the procedures to remove the label backing from the printed label to remove.

Removing the label backing

When the backing of a printed label is not cut,
use the included label stick. For labels printed
using the Half Cut option, peel back the
backing from the cut line.
Press the cover release button and open
1
the tape compartment cover.
2 Remove the label stick installed inside
the PT-9500PC tape compartment cover.
3 Hold one end of the printed label with
one hand and hold the label stick with
the other hand.
4 Insert half of the printed label into the
hole in the label stick with the printed
side facing up.
Turn the label stick and quickly pull as
5
shown in the illustration below.
→The end of the label will come off of
the backing slightly.
6 Completely remove the backing from the
label and affix the label.
91