Tabla de contenido
Idiomas disponibles
Idiomas disponibles
• For your convenience and safety, the following labels are on
your laser.
AVOID EXPOSURE: LASER RADIATION IS EMITTED FROM
THIS APERTURES.
DANGER: LASER RADIATION. AVOID DIRECT EYE
EXPOSURE.
Laser Information
The DW076 Cordless Rotary Laser is listed as a CLASS IIIA
LASER PRODUCT and complies with the applicable requirement
of title 21 of the Code of Federal Regulations set forth by: the
Department of Health, Education, and Welfare; the Food and Drug
Administration; the Center for Devices and Radiological Health.
These devices comply with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause unde-
sired operation.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio and television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit differentfrom
that which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
These Class B digital devices comply with Canadian ICES-003.
Important Safety Instructions for
Battery Packs
Your tool uses a 9.6, 12.0, 14.4 or an 18 Volt D
When ordering replacement battery packs, be sure to include cata-
log number and voltage. Extended Run-Time battery packs deliver
more run-time than standard battery packs. Consult the chart at the
end of this manual for compatibility of chargers and battery packs.
NOTE: Your tool will accept either standard or Extended Run Time
battery packs. However, be sure to select proper voltage. Batteries
slowly lose their charge when they are not on the charger, the best
place to keep your battery is on the charger at all times.
The battery pack is not fully charged out of the carton. Before using
the battery pack and charger, read the safety instructions below.
Then follow charging procedures outlined.
2
WALT battery pack.
E
Tabla de contenido
