Tabla de contenido
Idiomas disponibles
Idiomas disponibles
LEVEL
MODE
Using the Laser in Manual Mode
To activate manual mode, press the manual button (D) for at least
two seconds. The laser will not self level and the level indicator
lights (F, G) do not light while in manual mode. Manual mode may
be used in either level or vertical orientation.
Using the Laser in Vertical Mode
The laser can be positioned to be used in the vertical orientation.
The laser will not self level in vertical mode.
1. Place the laser on a smooth surface where it will not be
disturbed.
2. Position the laser vertically as shown.
3. The laser must be put in manual mode when used in vertical
orientation.
4. Turn the laser on by pressing the ON/OFF button (C).
Using the Laser with a Wall Mount
The DW076 Rotary Laser has been designed to work with an
accessory Wall Mount (DW0770). It can be used for attaching the
tool to track or celing angle (mould) and to aid in acoustical ceiling
installation. Follow the directions below for using the wall mount.
CAUTION: Before attaching the laser level to wall track or
ceiling angle, be sure that the track or angle is properly secured.
1. Attach the Laser to the accessory wall mount.
VERTICAL
MODE
9
2. With the wall mount measuring scale (H) facing you, rotate the
wall mount clamp locking knob (I) towards you to open the
clamp jaws.
H
I
3. Position the clamp jaws around the wall track or ceiling angle
and as shown rotate the wall mount clamp locking knob away
from you to close the clamp jaws shut on the track. Be sure that
the wall mount clamp locking knob is securely locked before
proceding.
CAUTION: Always use a ceiling wire
hanger or equivalent material, in addition to
the wall mount clamp, to help secure the laser
level while mounting it to a wall. Thread the
wire through the handle of the laser level. DO
NOT thread the wire through the protective
metal cage. Additionally, screws may be used
to fasten the wall mount directly to the wall as
a back up. Screw holes (J) are located in the
wall mount next to the measuring scales.
4. The tool can be adjusted up and down to
the desired offset height for working. To
change the height, loosen the Rack 'N
Pinion locking knob (K) located on the left
of the wall mount.
I
J
K
L
Tabla de contenido
