Tabla de contenido
6
Use
The following type of joint can be made with the jointing system
VS 600 and respective template:
• Dovetail joint
• Slotted box joint
• Dowel holes
• Open dovetail tenons
6.1
Dovetail joints
a)
Inserting the template
• Lock the tow swivel segments (6.1) in the central (vertical) posi-
tion with the clamping lever (6.2).
• Open both clamping levers (7.1, 7.3) to adjust the height of the
template and press the mount (7.2) for the templates right
down.
• Open the rotary knobs (7.4, 7.7) to clamp the template and insert
the template (7.5).
Caution: the two adjusting wheels (7.6) must point down-
wards.
• Close the two clamping levers to adjust the height of the tem-
plate.
• Align the template so that the lower shoulders (8.1) of the two
adjusting wheels rest against the base frame of the jointing
system and clamp the template tight with the two rotary knobs
(7.4, 7.7).
• Turn the two stops into the positions "SZ 14" and "SZ 20"
(9.3).
Align the stops so that the arrows (9.1) lie against the inner
straight side (9.2) of the notches in the template.
Clamp the stops tight with the rotary knobs (9.4).
• Open the two clamping levers to adjust the height of the template
and move the template upwards.
• Place a workpiece under both ends of the template. Press the
template down until it rest fl at on the workpiece and close the
two clamping levers to adjust the height of the template.
18
(see Chapter 6.1),
(see Chapter 6.2),
(see Chapter 6.3),
(see Chapter 6.4).
Tabla de contenido
