Solo 155 Manual De Instrucciones página 31

B) Fitting the nylon head
(Accessory No.: 69 00 652 6)
Note: When fitting the nylon head, the collar washer
(42), the disc (43), the spring washer (44) and the
locking nut (45) are not required.
Fig. 8
! Position thrust piece (38) on gear shaft (39). Ensure
that the chamfered edge points towards the
gearbox.
! Rotate the gear shaft with the thrust piece, so that
the recess for retaining pin (40) is flush with the
recess in winding protection (41) or the gearbox
casing.
! Insert the retaining pin to lock the gearbox.
! Rotate the complete nylon head with the additional
line winding protection (46) on the gear shaft
against the thrust piece. Please note: Left-hand
thread! Tighten anti-clockwise against the nylon
head.
! Fit the line cutter blade (48) with screw (49) and
washer (50) to the protective bar (47).
! Push the protective bar (47) from below onto the
shield. Slightly bend the protective bar in the
process.
Please Note: When operating with the nylon head,
never start the engine without fitted protection bar and
line trimming blade.
Note: When the nylon line length is adjusted (
chapt."8.3 Adjusting the nylon line"
will trim the line automatically to the correct length.
Information regarding the guard bar (47):
Always operate without the guard bar when using the
grass cutting blade.
Fitting the protective guard is compulsory when using
the cutter head "Jet-Fit-Flexiblade" described in the
following. For a more detailed overview, see chapter
"10. Accessories".
see
), the line trimmer blade
C) Installation of the "Jet-Fit-Flexiblade" cutting
head (available as an accessory)
Fig. 9a
Fig. 9b
Order of assembly:
Fig. 9c
When fitting the "Jet-Fit-Flexiblade" cutter head, order
the adaptor washer 00 31 629 (25.75 x 11.9 x 2 mm)
separately, as it is not part of the standard delivery.
Hold the drive shaft again with the locking pin (40) to
tighten the locking nut (45).
No alternative method of assembly is permissible.
Fig. 9d
When using the "Jet-Fit-Flexiblade" cutting head,
always use the standard guard and the assembled
protective bar.
Cutting lines must not touch the guard during rotation.
If necessary, insert the cutting lines slightly further into
the main body of the cutting head. The line trimmer
which is assembled in the protective bar is not suitable
for cutting lines. ! The length of the cutting lines
needs to be manually adjusted to the correct length.
Preparing the equipment for use
Insert the cutting line
into the main body of
the cutting head in
accordance with the
arrows on the main
body. Insert enough line
so that approx. 20 mm
of the cutting line
protrudes from the
opening on the opposite
side.
Make sure that the
cutting teeth are
correctly aligned in the
direction of rotation.
Fit the cover of the
cutting head in place,
turn it in the direction of
the arrow and tighten it
with the combination
wrench as shown in the
illustration until it
engages.
ENGLISH 11