Operation And Use - Topcom BABYVIEWER 4500 Manual De Usuario

8.4 Installing the rechargeable battery pack in the parent unit
See Figure B on the fold-out page.
CAUTION
• Use only the supplied Li-ion battery pack in the parent unit.
– Rotate the belt clip
– Turn the screw on the cover
the back of the parent unit 90° counter clockwise and remove
the battery compartment cover.
• Do not turn the screw past the "OPEN" point.
– Place the Li-ion battery pack in the battery compartment.
Ensure that the battery contacts do make contact with the
charge contacts as illustrated.
– Carefully close the battery compartment and rotate the belt clip
back downwards.
8.5 Connecting the parent unit to the AC mains
– Insert the small plug of the AC mains adapter in the mains power connector
adapter into a mains connector (100~240 V - 50/60 Hz).
• It takes around 10 hours to fully charge the batteries.
9 Installing the Babyviewer 4500
9.1 Fine tuning
• Place the camera in a convenient location, point the lens of the camera
to the observation area.
• Adjust the angle by rotation the camera.
CAUTION
Do not place the camera and wires within the baby's reach!
Fix the camera at least 1 meter away from the baby.
9.2 Fixing the camera
Use the crib connector to fix the baby unit to the crib. (See illustration)

10 Operation and use

10.1 Switching the baby unit and parent unit on and off
– Press the on/off switch
– Slide the on/off switch
• The parent unit will try to establish a connection with the baby unit. If captured image from
the camera is displayed, a connection has been established.
– Press the on/off switch
– Slide the on/off switch
10.2 Checking the connection between the parent unit and the baby unit
You should always check the wireless connection when you use the babyphone for the first time.
– Put the parent unit in the same room as the baby unit, separated by at least two metres.
– Switch on both devices. The parent unit will try to establish a connection with the baby unit.
– The display of the parent unit will show the captured image from the baby unit after the connection has
been established (monitor mode).
– The sounds picked up by the microphone
6
upward.
26
of the battery compartment at
29
to switch on the parent unit. The display
29
up to switch on the baby unit. The on/off LED
4
to switch off the parent unit (press and hold until the display goes blank).
29
down to switch off the baby unit.
4
6
are reproduced by the parent unit.
Babytalker 3500 SEDS
and plug the AC mains
28
is activated.
20
is activated.