Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Compact Equipment Manual for residential fitted Spas
Use an H07-RNF cable from the differential switch to the electrical cabinet of the Spa. The cable
section will differ depending on the fitting of the electrical equipment and the distance of the
installation.
Use the following table to determine the cable section. The required kW can be identified in the
appendix sheet of Technical Specifications of the compact equipment in the section Maximum
Consumption.
6 – 11 m
11 - 15 m
15 – 20 m
For longer distances, the cable section must be increased.
WARNING – If the cable used is not suitable for the distance and power of the equipment, it will
not work properly and the installation may be damaged.
3. Open the electrical switchboard, pass the supply cable through the packing gland marked 230 V.
Fasten the 2 terminals and connect them to terminal strip 1 -2 as indicated in the figure.
earthing cable should be connected to the connection marked earth.
Detail of the terminal strip
1
2
INPUT
4. Check that the differential switch is in the OFF position. Do not put the differential switch in the ON
position until the Spa is full of water.
ATTENTION
Check that earthing of the installation is correct.
Do not connect the electrical supply (differential switch in the ON position) until the Spa is full
of water.
Table of required sections, distance and power
2.1
2.5
2.8
2.5
2.5
2.5
2.5
2.5
4
4
EARTH
3
4
5
HEATING
FILTERING
Required kW
3.2
3.5
4.4
Nominal cable section in mm
2.5
4
4
4
4
4
6
4
6
6
6
6
7
8
JETS
GREEN
RED
OFF
ON
7
5.3
6.2
7.0
7.9
2
6
10
10
10
6
10
10
10
10
10
10
16
PHASE
NEUTRAL
9
10
11
12
BLOWER
OPERATION
HEATING
English
.
8.8
10
10
16
The
Capítulos
Tabla de contenido
Solución de problemas
