Setting The E.box With Dip Switches; Activation Of The Set; Figure 39: System Status In Configurations: A With Only Depth Sensor, B: Depth Sensor And Floats, C Depth Sensor And Level Probes; Figure 40: Setting The Drainage Dip Switches - DAB E.Box Plus Instrucciones De Instalación Y Mantenimiento

In point 7 it is possible to choose the type of signal that will generate the maximum and minimum level alarms. Floats,
level probes or the data provided by the depth sensor may be used. If the depth sensor is used, the maximum ML and
the minimum LL level alarm thresholds must be set in accordance with Figure 43. The installation sequence with only
the depth sensor is shown.
System status and starting
Figure 39: System status in configurations: A with only depth sensor, B: depth sensor and floats, C depth sensor and

7.10 Setting the E.box with dip switches

If the E.box is provided with a display, it is recommended to use the display for configuration. Otherwise it is possible
to use the dip switches inside the panel and set them as shown in Figure 40 Setting dip switches for drainage.

7.11 Activation of the set

To activate the set it is necessary to enable the pumps. During the first configuration, for safety's sake, the
pumps are disabled and are OFF. To change to automatic mode, just briefly press the
pumps P1 and P2. As shown in Figure 41.
ENGLISH
level probes

Figure 40: Setting the Drainage dip switches

Figure 41: Enabling P1 and P2.

97
buttons on the