Quick Programming Guide; Configuring The Different Parameters - Fermax CITYLINE DUOX Serie Manual De Instalador Y Usuario

DUO DUO X CITYLINE KIT 1-2L X CITYLINE KIT 1-2L
DUOX CITYLINE KIT 1-2L DUO DUO X CITYLINE KIT 1-2L X CITYLINE KIT 1-2L
DUO DUOX CITYLINE KIT 1-2L DUO X CITYLINE KIT 1-2L X CITYLINE KIT 1-2L X CITYLINE KIT 1-2L
DUO DUO X CITYLINE KIT 1-2L

QUICK PROGRAMMING GUIDE

1. ENCODING PANELS
Whenever there are more than one panel (to a block) you must program the panel
number, but for this you need key 7439.
Connecting the keypad:
a) With the disconnected power, use the 5 way cable to connect the keypad as shown in
the diagram.
b) Reconnect the power supply. Now you can program the required parameters with the
keypad.
c) Before performing the operation to disconnect the keypad, remove the power.
5 way cable
PUT
NTRITT
The entry panel's parameters can be programmed on the keypad.
1.1 Access programming: A + 4444 (default code).
If the code is correct, a confirmation tone sounds (beep-beep).

1.2 Configuring the different parameters

The configuration of a parameter is done by entering: two digits of its position, and a
beep is heard and the desired value (1,2,3 or 4 digits relative to the parameter function).
If the value is correct, a confirmation tone sounds (beep-beep) and the new value is
saved. If not correct you will hear the error sound (beep-bop).
In order to exit the programming press 'A' when we are entering the menu's parameter
number. You can also exit by waiting 60 seconds without pressing any key.
Configuration of a parameter:
A + access code for programming + position + possible values
PROGRAM THE PANEL NUMBER,
Adjustments Parameter Possible Values [default]
Position
Panel No. (PL)
06
Configuration of a panel number:
A + 4444 + 06 + 0-9
Example:
•
Change panel number 2:
A 4444 (beep-beep) 06 (beep) 2 (beep-beep)
Pag 24
CN9
SW1
SW1 PROG
CN9 TAMPER
CN2
ENTRADA/INPUT
ARRIVÉE/EINTRITT
CN1
CN1
UP
SALIDA/OUTPUT
SORTIE/AUSGANG
CN1
DUOX AMPLIFICADOR
CN1
AMPLIFIER
A
AUDIO
B
C
CN1 PACK EXTENSION
D
E
F
DL2
DL2 LED
IDIOMA
LANGUAGE
ONE
EXIT
TO
BUS
ONE 18Vdc
CN3 P2 B B C NO NC BS - S + P1
+12 GND
NC
VERSION
:
C
NO
CN1
CN1
MÓDULO TECLADO
KEYPAD MODULE
MODULE CLAVIER
TASTATURMODUL
CN2
0-9 [0]
PL 2
MARCAR TIPO
EG BK SB
1 2 3
4 5 6
7 8 9
A 0 B
Comments
Panel number
NÚMERO
BK SB PL
2