Rollixo Optimo RTS
3.1.2
Safety edge operation
Activation of the safety edge when opening = disregarded, the door continues moving.
Activation of the safety edge when closing = stop + partial reopening.
3.2
Specific modes
Depending on the additional devices installed and the operating options programmed by your installer, the
motorisation may operate in the following specific ways:
3.2.1
Operation with a 3-button remote control
Up button
Complete opening
3.2.2
Photoelectric cells operation
Cells obscured when opening = the state of the cells is disregarded, and the door continues to move.
Cells obscured when closing = stop + complete reopening.
3.2.3
Operation with orange flashing light
The orange light is activated 2 s before the door begins moving in sequential mode with automatic closure
after a time-delay.
3.2.4
Area lighting operation
Integrated lighting comes on with the motor, and goes out 60 seconds after the motor has come to a com-
plete stop.
If a remote control is programmed to control the lighting, it operates as follows:
With a 2 or 4 button remote control
With a 3-button remote control
3.2.5
Operation in sequential mode with automatic closing after time delay
The door closes automatically after a time-out programmed during installation.
A new command during this time-out cancels automatic closure and the door remains open.
The following command causes the door to close.
©
Copyright
2019 SOMFY ACTIVITES SA. All rights reserved.
My button
Stop
Down button
Complete closing
STOP
EN
13