Measurement Operation; Dc Voltage Measurement - Urrea SURTEK 111002 Manual De Usuario Y Garantía

Multimetro digital de autorango
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

MEASUREMENT OPERATION

A.

DC Voltage Measurement

(Figure 3)
Warning
To avoid harms to you or damages to the
Meter from electric shock, please do not
attempt to measure voltages higher than
500V although readings may be obtained.
The DC Voltage ranges are : 400 mV, 4 V, 40 V, 400 V
and 500 V
1. Insert the red test lead into the VΩmA terminal and
the black test lead into the COM terminal.
2. Set the rotary switch to V
3. Connect the test leads across with the object being
measured. The measured value shows on the display.
Note:
• DCV Measurement is autoranging, the Meter has an
input 10MW. This loading effect can cause measurement
errors circuits.
range.
If the circuit impedance is less than or equal to
negligible (0.1% or less).
• When DC voltage measurement
has been completed, disconnect
between the testing leads and the
circuit under test.
Figure 3
E N G L I S H
29

Capítulos

Tabla de contenido
loading

Tabla de contenido