Rules For Safe Operation - Urrea SURTEK 111002 Manual De Usuario Y Garantía

E N G L I S H
CAT. I: Signal level, special equipment or parts
of equipment, telecommunication, electronic,
etc., with smaller transient overvoltages than
overvoltages CAT. II.
CAT. II: Local level, appliance, PORTABLE
EQUIPMENT etc.,
overvoltages than CAT. III.
Use the Meter only as specified in this operating
manual, otherwise the protection provided by the
Meter may be impaired.
In this manual, a Warning identifies conditions
and actions that pose hazards to the user, or may
damage the Meter or the equipment under test.
A Note identifies the information that user should
pay attention on.
International electrical symbols used on the Meter
and in this Operating Manual are explained on
page 6.
24
with smaller transient

RULES FOR SAFE OPERATION

Warning
To avoid possible electric shock or personal injury, and to
avoid possible damage to the Meter or to the equipment
under test, adhere to the following rules:
• Before using the Meter inspect the case. Do not
use the Meter if it is damaged or the case (or part
of the case) is removed. Look for cracks or missing
plastic. Pay attention to the insulation around the
connectors.
• Inspect the test leads for damaged insulation or
exposed metal. Check the test leads for continuity.
Replace damaged test leads with identical model
number or electrical specifications before using
the Meter.
• Do not apply more than the rated voltage, as
marked on the Meter, between the terminals or
between any terminal and grounding.
• The rotary switch should be placed in the right
position and no any changeover of range shall be
made during measurement is conducted to prevent
damage of the Meter.