Dometic MS 880 Instrucciones De Montaje página 31

MS880
➤ Release the brake.
✓ You will hear four acoustic signals.
✓ You are now in setup mode and can set the cruise control.
12.3 Adjusting the accelerator pedal manually
In this mode, the accelerator pedal parameters are taught to the electronic module
manually.
I
NOTE
• After each programming step is successfully completed, it is
confirmed by an intermittent tone of the same pitch. If there is an
intermittent tone of differing pitch, this step has failed and the
programming must be repeated from step 1.
• Some accelerator pedals do not provide sufficient electric signals
when fully pressed down. In this case, only press the pedal approx.
three-quarters of the way down, as otherwise programming will not
be successful.
Step 1
➤ Start setup mode (chapter "Starting setup mode" on page 30).
➤ Apply the brake and hold it down.
➤ Press the RES button once.
✓ An low-pitched acoustic signal sounds.
➤ Release the brake.
Step 2
➤ In neutral position (accelerator pedal is not pressed down), press the SET-button
once.
✓ The idling value is programmed.
Step 3
➤ Press the accelerator pedal down as far as it will go and press the RES button
once.
EN
Synchronising with an analogue connection
31