Synchronising With A Can-Bus Connection - Dometic MS 880 Instrucciones De Montaje

MS880
11 Synchronising with a CAN-bus
connection
Step 1 (synchronisation)
➤ Press and hold the SW1 button on the rear of the electronic module.
➤ Switch on the ignition.
✓ You will hear two high-pitched signals.
➤ Let go of the SW1 button.
➤ Manual transmission: Apply the brake and clutch pedal and keep both
pressed down.
➤ Automatic transmission: Apply the brake pedal and hold it down. Put the gear
into neutral.
➤ Press the SET button on the control element.
✓ The LED on the electronic module starts flashing.
✓ The electronics start to synchronise with the vehicle automatically.
✓ When the synchronisation is complete, you will hear three high-pitched signals.
✓ The LED on the electronic module lights up permanently.
➤ Manual transmission: Remove your foot from the brake and the clutch pedal.
➤ Automatic transmission: Remove your foot from the brake pedal and put the
gear into neutral.
I
NOTE
If you do not hear three high-pitched signals, check the connections
to CAN high (blue cable) and CAN low (blue/white cable) and check
whether MagicSpeed MS880 can be connected to the CAN bus in your
vehicle according to the vehicle list.
✓ After successful synchronisation, the electronics automatically continue with
step 2 (pedal test).
EN

Synchronising with a CAN-bus connection

27