Makita AN930H Manual De Instrucciones página 6

ENGLISH (Original instructions)
1. Safety glasses
2. Face shield
3. Compressor air output per minute
4. Nailing frequency
5. (L/min)
6. (times/min)
7. Adjuster
8. Too deep
9. Flush
10. Too shallow
11. Hook
12. Screw
13. Hole
14. Protrusion
15. Nose adapter
16. Push
17. Latch lever
SPECIFICATIONS
Min. hose diameter
Dimensions (L x W x H)
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
......... Read instruction manual.
.......... Wear safety glasses.
...................... Do not use on scaffoldings, ladders.
Intended use
The tool is intended for the preliminary interior work such
as fixing floor joists or common rafters and framing work
in 2 "x 4" housing.
Pneumatic nailer/stapler safety
warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in serious injury, electric shock
and/or fire.
6
Explanation of general view
18. Door
19. Adjust shaft
20. Arrow
21. Change plate
22. Feed claw
23. Driver channel
24. Trigger for continuous nailing
25. Silver part
26. Trigger for intermittent nailing
27. Black part
28. Urethane washer
29. Pin
30. Lock lever
31. Trigger
32. Contact element
33. Workpiece
34. Pull the trigger
Model
Air pressure
Nail length
Nail capacity
Net weight
Wire-collated coil nail 45 mm - 90 mm
Sheet-collated coil nail 45 mm - 75 mm
Wire-collated coil nail 120 pcs ~ 300 pcs
Save all warnings and
END106-3
instructions for future reference.
For personal safety and proper operation and
maintenance of the tool, read this instruction manual
before using the tool.
General safety
• Do not permit those uninstructed to use the tool.
• No horseplay. Respect the tool as a working
implement.
• Do not operate when under the influence of alcohol,
drugs or the like.
ENE059-1
• Never alter the tool.
Personal protective equipments
• Always wear safety glasses to protect your eyes from
dust or fastener injury.
WARNING: It is an employer's responsibility to
enforce the use of safety eye protection equipment by
ENB109-5
the tool operators and by other persons in the
immediate working area.
For Australia and New Zealand only
Always wear safety glasses and face shield to protect
your eyes from dust or fastener injury. The safety
35. Place the contact element against
workpiece.
36. Place first the contact element
against workpiece.
37. Thickness of workpiece
38. 10 mm or more
39. C-shaped steel (Thickness 1.6 -
3.2 mm)
40. Nail length
41. Wood thickness
42. Concrete range 10-15 mm
43. Cap
44. Drain cock
45. Thinner
46. Srove
AN930H
1.18 - 2.26 MPa (11.8 - 22.6 bar)
Sheet-collated coil nail 200 pcs
4.0 mm
286 mm x 128 mm x 330 mm
2.6 kg