Boost Mode; Stopping The External Power Supply - Maurer Elektromaschinen Acctiva Professional Flash Instrucciones De Uso

Boost mode

If the battery voltage drops while power is being supplied externally because more power
is needed (e.g. because additional consumer loads are switched on), the device goes
into boost mode.
Important! To keep the battery voltage at a constant level, the charger can increase the
current to the set external supply current. In prolonged periods of high current demand,
the charger will automatically decrease the current once the maximum operating tempe-
rature is reached.
Stopping the
external power
supply
1.
2.
3.
4.
CAUTION! Risk of sparks when disconnecting the charging terminals. Before
disconnecting the charging terminals, stop external power supply by pressing
the Start/Stop button.
Stop the external power supply
Disconnect (-) charging terminal from the negative pole of the system being sup-
plied, or from the vehicle body (e.g. engine block) in the case of vehicle electrical
systems
Disconnect (+) charging terminal from the plus cable of the system being supplied
11