Watching The Converted Picture; Converting The Picture; Using The Line Doubler - Sony DSC-1024G Manual De Instrucciones

Watching the converted picture

1
S
ON/OFF
DISPLAY ON/OF
button
Before you start
• Turn on the connected equipment and play a video source.
• To display the information on the current operation on the
screen, make sure the indicator of the DISPLAY ON/OFF
button is lit. If not, press the DISPLAY ON/OFF button.
• To set the on-screen language to yours, see page 44.

Converting the picture

1 Press the ON/OFF switch.
The indicator of the ON/OFF switch and all the three
INPUT SELECT buttons light.
ON/OFF
2 Select the input source to be converted by pressing the
INPUT SELECT button.
The pressed button lights brighter than the others, and the
input signal indicator lights to show the input signal
format (see page 47).
INPUT SELECT
1 2 3
3 Select the desired output signal format by pressing the
OUTPUT FORMAT button repeatedly.
The selected output signal indicator lights. The output
signal is switched a few seconds after you release the
button.
For the specification of each output format, see page 47.
OUTPUT
FORMAT
34
3
IN/OUT indicators
TV
IN NTSC PAL
PJ
OFF
DISPLAY TEST LINE OUTPUT OUT NTSC PAL
COMMAND
MODE ON/OFF PATTERN DOUBLER FORMAT GEN-LOCK
MENU
CENT
ENTER
CENT◊/√ buttons
Selected input
VIDEO 1
NTSCzNTSC
VIDEO 1
NTSCz31.5k
Input signal Output signal
format
format
OVER FLOW
SIGNAL FORMAT
31.5k 37k 48k 64k OTHERS
31.5k 37k 48k 64k APERTURE
CHROMA PHASE CONTRAST
SIZE
LINE DOUBLER button
STILL button

Using the line doubler

The line doubler function of this unit converts the input NTSC
or PAL signal into a digitally interpolated, high scan-rate
output signal. The output signal format becomes a non-
interlaced signal whose horizontal frequency is 31.5 kHz and
vertical frequency is synchronized to the input signal.
The line doubler up-converts the signal field by field by
interpolating information on two line signals vertically.
Therefore, a fast moving picture is reproduced as a natural
high-resolution picture.
• The converted signal is output from the RGB/component
output connector in the RGB format.
• The line doubler can be activated for the three inputs
separately.
Activating the line doubler
1 Press the OUTPUT FORMAT button to select 31.5k.
2 Connect a NTSC or PAL signal source and select the
input with the INPUT SELECT buttons.
3 Press the LINE DOUBLER button.
The indicator of the button lights, and the NTSC and 31.5k
or the PAL and 31.5k OUT indicators light.
LINE
DOUBLER
When the input source is NTSC
OUT NTSC PAL 31.5k
GEN-LOCK
When the input source is PAL
OUT NTSC PAL 31.5k
GEN-LOCK
2
OPEN SCAN CONVERTER DSC-1024G
INPUT SELECT
STILL
1 2 3
ZOOM
37k
NTSCzLINEx2
37k
PAL zLINEx2