Troubleshooting; Technical Data; Warranty - Powerworks P48LM35 Manual Del Operario

6

TROUBLESHOOTING

Problem Possible cause
The handle is The bolts are not
not in position. engaged correct-
ly.
The machine The battery ca-
does not start. pacity is low.
The bail switch is
defective.
The battery key
is not put in.
The machine The lawn is
cuts grass un- rough.
evenly.
The blade height
is not set cor-
rectly.
The machine Wet grass clip-
does not mulch pings attach to
correctly. the deck.
The mulch plug
is missing.
The machine is The grass is too
hard to push. tall, or the blade
height is too low.
The grass catch-
er and the blade
drags in thick
grass.
There is a high The blade is un-
vibration in the balanced and
machine. worn.
The engine shaft
is bent.
English
Problem
The machine
Solution
stops during
Adjust the height mowing.
of the handle
and make sure
that the knobs
and bolts are
aligned correctly.
Charge the bat-
tery pack.
Replace the bail
switch.
Put in the battery
key.
* If you cannot find the solution to these problems, go to
the service center.
Examine the
mowing area.
7
Move the wheels
to a higher posi-
Voltage
tion.
No load speed
Wait until the
grass dries be-
Cut width
fore mowing.
Cut height
Install the mulch
Grass catcher capacity
plug.
Weight (without battery
Increase the
pack)
blade height.
Measured sound pressure
level
Empty the grass
clippings from
Measured sound power
the grass catch-
level
er.
Guaranteed sound power
Replace the
level
blade.
Vibration
Battery model
1. Stop the en-
gine.
2. Remove the
Charger model
safety key
and battery
pack.
8
3. Disconnect
the power
(The full warranty terms and conditions can be found on
source.
Powerworks webpage)
4. Inspect for
The Powerworks warranty is 3 years on the product,
damage.
and 2 years on batteries (consumer/private usage) from
5. Repair the
the date of purchase. This warranty covers
machine be-
manufacturing faults. A faulty product under warranty
fore you start
might be either repaired or replaced. A unit that has
it again.
been misused or used in other ways then described in
the owner's manual might be rejected for warranty.
Normal wear, and wear parts are not considered as
7
Possible cause
The blade height
is too low.
The battery pack
is out of power.
The grass clip-
pings attach to
the deck or the
blade.
Operation tem-
perature of the
machine is too
high.

TECHNICAL DATA

48 V
3600 / min
350 mm
20 - 70 mm
40 L
15.1 kg
L = 67.2 dB(A)
pA
L = 87.2 dB(A)
wA
L
wA.d
＜ 5 m/s
BAM701 and other BAM
series
CAM805 and other CAM
series

WARRANTY

Solution
Increase the
blade height.
Charge the bat-
tery pack.
Remove the bat-
tery pack and
check the deck.
Cool the ma-
chine.
= 90 dB(A)
2
EN