Operation Tips; Maintenance; General Maintenance; Lubrication - Powerworks P48LM35 Manual Del Operario

EN
• Monitor the holes, ruts, rocks, and other hidden
objects that can cause you to fall. Remove all
obstacles such as rocks and tree limbs.
• Make sure that your footing is stable. If you are out
of balance, release the bail switch immediately.
• Do not mow near drop-offs, ditches, or
embankments.
4.5

OPERATION TIPS

• Do not try to override the operation of the start
button or bail switch.
• Do not tilt the machine when you start it.
• Do not put hands or feet near or below the turning
parts.
• Keep the discharge chute clean.
• Do not cut wet grass.
• Higher blade height is necessary for new or thick
grass.
• Clean the bottom of the mower deck after each use.
Remove grass clippings, leaves, dirt, and other
debris.
5

MAINTENANCE

Remove the safety key and battery pack from the
machine before maintenance.
Keep the engine and battery pack free from grass,
leaves or too much grease.
Use only approved replacement parts.
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
5.1

GENERAL MAINTENANCE

• Before each use, examine the machine for
damaged, missing, or loose parts such as screws,
nuts, bolts and caps.
• Tighten correctly all the fasteners and caps.
• Clean the machine with a dry cloth. Do not use
water.
WARNING
WARNING
CAUTION
CAUTION
CAUTION
English
5.2

LUBRICATION

Apply sufficient quantity of high grade lubricant to all
bearings. No more bearing lubrication is necessary in
usual operation conditions.
Do not lubricate the wheel components. Lubrication
can cause damage to the wheel components during
operation.
5.3

REPLACE THE BLADE

Figure 9.
Use only approved replacement blades.
Wear heavy gloves or wind cloth around the blade
when you touch the blade.
1. Stop the machine.
2. Make sure that the blades fully stop.
3. Remove the safety key and battery pack.
4. Turn the machine to its side.
5. Use a piece of wood to prevent the movement of the
blade.
6. Remove the mounting screw and spacers with a
wrench or socket.
7. Remove the blade.
8. Install the new blade. Make sure that the raised
points engage the holes in the blade.
9. Put in the mounting screw and spacers and tighten
them.
5.4

STORE THE MACHINE

• Clean the machine before storage.
• Make sure the engine is not hot when you store the
machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service
center.
• Store the machine in a dry area.
• Make sure that children cannot come near the
machine.
6
WARNING
WARNING
WARNING