Detection By Photocell Or Safety Strip; Declaration Of Conformity - Erreka CLEVER02(M) Manual Del Instalador

DESCRIPTION OF THE PRODUCT
Closing: closing is carried out differently in accordance
with the JP1 configuration:
• Automatic mode (JP1=ENABLE): closing begins
automatically after standby.
• Step-by-step mode (JP1=DISABLE): closing begins
by briefly running the A.T. key command
(transmitter, magnetic key, key switch, etc).
Dead man mode (DIP1=ON and DIP2=OFF)
Opening: this begins by continuously pressing the A.T.
key command (push button, key switch, etc).
Standby: the shutter gate remains open until a key
command is received.
Dead man mode in closing (DIP1=ON and DIP2=ON)
Opening: this begins by briefly pressing the A.T. key
command (push button, key switch, etc).

Opening finishes when the time programmed by
T.M. finishes
3

DETECTION BY PHOTOCELL OR SAFETY STRIP

Opening safety device (SG.A)
Behaviour differs in line with the operation mode
selected:
During opening in dead man mode: if, during
opening, the opening safety device (SG.A) is enabled,
the shutter gate stops and remains on standby until
SG.A is released.
During opening in the other operation modes: if,
during opening, the opening safety device (SG.A) is
enabled, the shutter gate inverts operation direction
and slightly closes. The shutter gate remains on standby
until a key command is received.
During closing: the opening safety device (SG.A.) does
not run in any case.
4

DECLARATION OF CONFORMITY

Erreka Automatismos declares that the CLEVER02/
CLEVER02M electromechanical operator has been
designed for use in a machine or for assembly along
with other elements in order to form a machine in line
with Directive 2006/42/EC.
28
Installation Guide
In both cases, the shutter gate stops if the A.T. key
command is enabled during closing.

Closing finishes when the time programmed by way
of T.M. finishes
Closing: closing is carried out by continuously running
the C.T. key command (pushbutton, key switch, etc).

Closing finishes when C.T. is released
Standby: the shutter gate remains open until a key
command is received.
Closing: closing is carried out by continuously running
the C.T. key command (pushbutton, key switch, etc).

Closing finishes when C.T. is released
Closing safety device (SG.C)
Behaviour differs in line with the operation mode
selected:
During opening: the closing safety device (SG.C.) does
not run in any case.
During closing in dead man or dead man in closing
mode: if, during closing, the closing safety device
(SG.C) is enabled, the shutter gate stops and remains
on standby until SG.C is released.
During closing in the other operation modes: if,
during closing, the closing safety device (SG.C) is
enabled, the shutter gate inverts operation direction
and opens completely.
The CLEVER02/ CLEVER02M control panels comply
with safety legislation, in line with the following
directives and regulations:
• 2006/95/CE (low voltage materials)
• 2004/108/EC (electromagnetic compatibility)
• EN 60555-2