Working; Extracting Dry Materials; Extracting Fluids; After Finishing Work - Festool CTL 48 E LE EC Manual De Instrucciones

8

Working

8.1 Handling
SysDoc SYSTAINER attachment system: A SYSTAIN-
ER can be attached to the storage area using the four
locking latches [6-1].
8.2

Extracting dry materials

CAUTION
Hazardous dust
Damage to the respiratory passage

Always use a filter bag when extracting hazar-
dous materials!

Do not use the machine if the volumetric flow
monitoring function is inactive.
Observe the following when extracting dust generat-
ed by operating electric power tools:
If the exhaust air is discharged back into the room,
the air renewal rate L within the room must be suf-
ficient. The volume of air discharged back into the
room must not exceed 50% of the fresh air volume
flow (room volume V x air renewal rate L
R
all the relevant regional regulations.
Remember: A moist main filter clogs more quickly
when extracting dry materials. Therefore, dry the
main filter before extracting dust or replace the
damp filter with a dry one.
8.3

Extracting fluids

Before extracting fluids, remove the filter bag (see
Chapter 7.8). We recommend using a special wet filter.
The dust extractor stops automatically when the
maximum level is reached.
CAUTION
Escaping foam and fluids

Switch off the machine immediately and empty
the dirt trap.
8.4

After finishing work


Switch off the mobile dust extractor and pull out
the mains plug.

Wind up the mains power cable.

Empty the dirt trap.

Only CTM 48 E LE EC: Close off the extractor
opening [1-2] using the sealing plug [1-1].
Hazardous dust
Damage to the respiratory passage

Wipe down the mobile dust extractor and clean all
accessories thoroughly using the extractor (inside
and out) before removing from the working area.

Parts that you were not able to clean thoroughly
must be sealed in an airtight plastic bag prior to
transportation.

Wear a dust mask!
The machine shall be stored indoors only.

room inaccessible to unauthorised users.
9
Risk of injury, electric shock

Always disconnect the mains plug from the so-
). Observe
W cket before performing maintenance work on
the machine!

All maintenance and repair work which requires
the motor housing to be opened must only be
carried out by an authorised service workshop.
Damaged safety devices and components must be
repaired or replaced in a recognised specialist work-
shop, unless otherwise indicated in the operating
manual.
EKAT
2
1
Observe the following instructions:
– A dust test must be performed at least once a year by
the manufacturer or an instructed person. This test
may include checks to determine whether the filter is
damaged, the machine is sealed properly and the mon-
itoring features are functioning correctly.
– During maintenance and repair work, all compo-
nents that cannot be cleaned satisfactorily must be
replaced. The old components must be sealed in
impermeable plastic bags prior to disposal in com-
CTM 48 E LE EC, CTL 48 E LE EC
WARNING
Place the mobile dust extractor in a dry

Service and maintenance

WARNING
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
Only use original Festool spare parts!
4
Order No. at: www.festool.com/service
5
3
GB
17