Ottobock Myo Plus Instrucciones De Uso página 30

► Clean the product only as described in the section "Cleaning and care" (see Page 37).
CAUTION
Insufficient skin contact of the electrodes
Injury due to faulty control or malfunction of the product.
► The electrodes are to be placed on intact skin only and with as much electrode-skin contact
as possible.
► Use the different electrode dome heights to improve the skin contact.
► Make sure that skin contact of the electrodes continues to be given when carrying heavy
loads.
CAUTION
Insufficient space for electrode domes because distance is too small
Injury due to unexpected prosthesis behaviour.
Make sure that the electrode domes do not touch each other. Reduce the number of elec­
►
trode domes if necessary (e.g. if the arm is very thin).
► Watch the electrode contacts if the residual limb swings or moves.
► Use suitable dome heights according to the fit of the prosthetic socket.
CAUTION
Remaining in areas outside the allowable temperature range
Injury due to faulty control or malfunction of the product.
► Avoid remaining in areas outside the allowable temperature range (see Page 38).
CAUTION
Incorrect electrode settings due to muscle fatigue
Injury due to faulty control or malfunction of the product.
► The patient should take breaks during calibration.
CAUTION
Insufficient distance to HF communication devices (e.g. mobile phones, Bluetooth
devices, WiFi devices)
Injury due to unexpected behaviour of the product caused by interference with internal data
communication.
► Therefore, keeping a minimum distance of 30 cm from HF communication devices is recom­
mended.
CAUTION
Operating the product in very close proximity to other electronic devices
Injury due to unexpected behaviour of the product caused by interference with internal data
communication.
► Do not operate the product in the immediate vicinity of other electronic devices.
► Do not stack the product with other electronic devices during operation.
► If simultaneous operation cannot be avoided, monitor the product and verify proper use in
the existing setup.
30