DeWalt DWE1622 Manual De Instrucciones página 35

FILLING THE COOLANT BOTTLE
1. Make sure the flow regulator (M) is closed.
2. Unscrew the cap (V).
3. Fill the container with cutting coolant diluted with water.
4. Screw the cap back on.
Fitting the safety chain (Fig. 5)
WARNING: Always use the safety chain.
Thread the provided safety chain (O) through the handle of unit and
around the workpiece and secure in place.
FIG. 5
O
Inserting and removing an accessory
(Fig. 6)
The tool holder accepts annular cutters with a 19 mm shank with
two flats.
WARNING: The teeth of a cutter are very sharp and can be
dangerous.
1. Slide the pilot pin through the
hole in the center of the cutter
shank.
2. Push up on the quick-release
collar (W).
3. Insert the cutter (X) with pilot
pin and turn until the flat meets
the locking pin. When the flat
meets the locking pin the collar
will snap down.
4. Check that the cutter is
securely held in the arbor.
5. Lift the collar to release the
cutter.
3-JAW CHUCK (FIG. 7)
A D WALT 3-jaw chuck (Y) can be
E
installed using an adaptor (Z) to fit
the drill press for various bit sizes.
Refer to Inserting and
Removing an Accessory for
installation instructions.
NOTE: It may be necessary to
adjust the motor position when
chuck is installed. Please refer to
Adjusting the Motor Height for
instructions.
Consult your dealer for further
information on the appropriate
accessories.
33
FIG. 6
2
1
W
X
FIG. 7
2
1
W
Z
Y