DeWalt DWE1622 Manual De Instrucciones página 31

Ocultar thumbs Ver también para DWE1622:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

• Keep the magnet clean and free of debris and swarf.
• Do not switch on the machine until it has been mounted and
installed according to the instructions.
• Do not switch on the machine before having checked that the
magnetic stand has been tightened firmly to the mounting surface.
• Adjust the table or depth stop to prevent the drill from entering the
workpiece. Do not perform any design, assembly or construction
activities on the workpiece while the machine is switched on.
• Before switching on the machine, make sure the accessory has
been mounted correctly.
• Always use the recommended speed for the accessories and the
material.
• Do not use the machine on the same workpiece on which electric
welders are being used.
• Use only an appropriate cutting fluid. Use a general non-oil based
metal cutting coolant diluted with water.
• Do not use liquid cutting fluids while drilling vertically or overhead.
Dip the cutter in cutting paste or apply an appropriate spray for
these applications.
• Do not pour cutting fluid into the reservoir while it is mounted in the
bracket. Do not allow cutting fluid to enter the drill motor.
• Air vents often cover moving parts and should be avoided.
Loose clothes, jewelry or long hair can be caught in moving parts.
• An extension cord must have adequate wire size for safety.
An undersized cord will cause a drop in line voltage resulting in loss
of power and overheating. When using more than one extension
to make up the total length, be sure each individual extension
contains at least the minimum wire size. The following table shows
the correct size to use depending on cord length and nameplate
ampere rating. If in doubt, use the next heavier gauge. The smaller
the gauge number, the heavier the cord.
Voltage (Volts)
Total length of cord in meters (m)
120–127V
0–7
220–240V
0–15
Rated Ampere
Minimal cross-sectional area of the
range
0–6A
1.0
6–10A
1.0
10–12A
1.5
12–16A
2.5
WARNING: If the plug or cord are damaged it must be replaced
by the manufacturer or its agent, or an equally qualified person to
avoid danger.
WARNING: Some dust created by power sanding, sawing,
grinding, drilling, and other construction activities contains chemicals
known to cause cancer, birth defects or other reproductive harm.
Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber (CCA).
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed to
filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with
soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
29
7–15
15–30
30–50
15–30
30–60
60–100
cord in meters (mm
2
)
1.5
1.5
2.5
1.5
2.5
4.0
1.5
2.5
4.0
4.0
Not Recommended
Tabla de contenido
loading

Tabla de contenido