Intended Use - DeWalt DWE1622 Manual De Instrucciones

WARNING: Use of this tool can generate and/or disburse dust,
which may cause serious and permanent respiratory or other injury.
Always use NIOSH/OSHA approved respiratory protection appropriate
for the dust exposure. Direct particles away from face and body.
WARNING: ALWAYS USE SAFETY GLASSES. Everyday
eyeglasses are NOT safety glasses. Also use face or dust mask if
cutting operation is dusty. All users and bystanders MUST ALWAYS
wear certified safety equipment:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
WARNING: Always wear proper personal hearing protection
that conforms to ANSI S12.6 (S3.19) during use. Under some
conditions and duration of use, noise from this product may
contribute to hearing loss.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ................... volts
Hz ................. hertz
min ............... minutes
or DC ... direct current
................. Class I Construction
..................... (grounded)
................. Class II Construction
(double insulated)
.../min .......... revolutions per minute .......................speed
BPM ............. beats per minute
IPM ............... impacts per minute
SPM ............. strokes per minute
sfpm ............. surface feet
..................... per minute
.....................
A ......................amperes
W .....................watts
or AC ..........alternating
current
or AC/DC ...alternating
........................or direct
current
n o ....................no load
n ......................rated
........................speed
.....................earthing
terminal
.....................safety alert
symbol
30
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
Motor
Be sure your power supply agrees with the nameplate marking.
Voltage decrease of more than 10% will cause loss of power and
overheating. D WALT tools are factory tested; if this tool does not
E
operate, check power supply.
WARNING: This product is Class 1 Construction and must
be connected to an Earth connection.
DESCRIPTION (Fig. 1, 5)
WARNING: Never modify the power tool or any part of it. Damage
or personal injury could result.
A. ON/OFF power/magnet
switch
B. Off button for motor
C. On button for motor
D. Gear selector
E. Magnetic bracket
F. Feed handle
G. Hub

INTENDED USE

DO NOT use under wet conditions or in presence of flammable
liquids or gases.
DO NOT let children come into contact with the tool. Supervision is
required when inexperienced operators use this tool.
H. Tool holder
I. Guard
J. Coolant bottle
K. Coolant tube
L. Quick release connector
M. Flow regulator
N. LED indicator light
O. Safety chain (Fig. 5)