Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation
Disconnect supply voltage!
NOTE
If, when installing the device, the physical address has not
yet been allocated, the programming button (Fig. 1, Pos. 1)
should still be accessible.
Installation
The control module has been designed for installation in
distribution boards.
• Clip the control module onto the DIN rail by means of the
snap-on mounting.
• Cover the bare area of the rail.
• Connect via the terminal block provided as shown in
Fig 2.
Please also take the connection data under "Technical Data"
into account.
Connection of the dimmer
• Connect the control module with input D of the relevant
dimmer via output D1 (D2).
• Only now connect the supply voltage of the dimmer.
GB
Tabla de contenido
