Installing Refl Ectors & Supports - L.B.White Oval 80 v.2 Manual Del Propietario E Instrucciones

14
Oval 80 v.2 and Sentinel v.2
Installing Reflectors & Supports
Refer to Fig. 9 and the following instructions:
1. Slide the refl ector through the hangers until it is
about 1 or 2 inches away from the burner box.
2. Attach end cap to end of this refl ector.
Use 4 U-clips. Push this refl ector up to burner box.
3. Sentinel Heaters Only: Install a support at end of
refl ector nearest burner box and at middle and
ends of all refl ectors. Do not install a support
directly next to a hanger on the same refl ector.
FIG. 9
FLANGE
CONNECTOR STRIP
(DIMPLES UP)
DOTTED LINES: INDICATE
CONNECTOR WITHIN FOLDED
CHANNEL
Owner's Manual • Oval 80 v.2 and Sentinel v.2
Radiant Tube Heaters
CONNECTION STRIPS:
• Insert a connection strip halfway
into the folded channel at both
sides of a refl ector, at the end
without fl anges.
• Slide this end of the refl ector
through the hanger and push it
fi rmly into the folded channels of
the refl ector at the burner box.
REFLECTOR END VIEW
SHOWING FOLDED
• The unfl anged end of the refl ector
CHANNEL
will overlap the fl anged end of the
adjacent refl ector.
4. Connect the refl ectors using the dimpled con-
nector strips. See below.
5. Repeat Steps 3 and 4 for remaining refl ectors.
6. Attach remaining end cap to last refl ector with
U-clips.
SUPPORTS
OVERHEAD
SUPPORT