Preparing Shrub Shears For Operation; Charging The Battery, Leds; Mounting The Charger On A Wall - Stihl HSA 26 Manual De Instrucciones

5 Preparing Shrub Shears for Operation

￭ Aggressive cleaning agents, a water jet or pointed objects
can damage the shrub shears, cutting blades, battery and
charger. If the shrub shears, cutting blades, battery or
charger are not cleaned correctly, components may no
longer function properly or safety devices may be
rendered inoperative. This can result in serious injuries.
► Clean the shrub shears, cutting blades, battery and
charger as described in this instruction manual.
￭ If the shrub shears, cutting blades, battery or charger are
not serviced correctly, components may no longer
function properly or safety devices may be rendered
inoperative. This can result in serious or fatal injuries.
► Do not attempt to service or repair the shrub shears,
battery or charger.
► If the shrub shears, battery or the charger require
servicing or repairs: Contact a STIHL servicing dealer
for assistance.
► Maintain the cutting blades as described in this
instruction manual.
￭ The user can be cut by the sharp cutting edges while
cleaning or servicing the cutting blades. This can result in
personal injury.
► Wear work gloves made of durable material.
5 Preparing Shrub Shears for Operation
5.1 Preparing Shrub Shears for Operation
Perform the following steps before starting work:
► Make sure the following components are in a safe
condition:
– Shrub shears, @ 4.6.1.
– Cutting blades, @ 4.6.2.
– Battery, @ 4.6.3.
– Charger, @ 4.6.4.
► Check the battery, @ 10.2.
► Fully charge the battery, @ 6.2.
0458-601-9821-A
► Clean the shrub shears, @ 15.1.
► Check the controls, @ 10.1.
► If 3 LEDs flash red while you are checking the controls:
Remove the battery and contact your STIHL dealer for
assistance.
There is a malfunction in the shrub shears.
► If you cannot carry out the above steps: Do not use your
shrub shears and contact your STIHL servicing dealer.

6 Charging the Battery, LEDs

6.1

Mounting the Charger on a Wall

The charger can be mounted on a wall.
1 2
a
b
a
► Check the following points when mounting
the charger on a wall:
– Suitable fixing materials.
– The charger is level.
– The following dimensions are observed:
– a = at least 100 mm
– b = 54 mm
– c = 4.5 mm
– d = 9 mm
– e = 2.5 mm
English
3
d
e
e
47