Siemens LC8M950 Instrucciones De Uso Y De Montaje página 30

Installation
This extractor hood is intended to be
mounted onto the kitchen wall.
1. Remove the grease filter (refer to
Operating Instructions).
2. Draw a line on the wall from the ceiling
to the lower edge of the hood at the
centre of the location where the hood is
going to be mounted.
3. Use the template to mark the points on
the wall where the screws will be moun-
ted. In order to make it easier to hook
the hood onto the screws, draw the out-
line of the area where the hood will be
attached.
Ensure that the minimum distance
between the hob and extractor hood is
550 mm for electric hobs.
The bottom edge of the template equates
to the lower edge of the extractor hood.
4. Drill 2x 8 mm ø holes for the upper fixing
bracket and 2x 8 mm ø holes for the
lower fixing bracket and press in wall
plugs flush with the wall.
min. 550
recommendation 650
30
Note: Take into account any special
accessories that are going to be fitted.
5. Screw on the upper and the two lower
fixing brackets.
6. Attach the extractor hood.
Adjust the height and align horizontally
Supply for
with the adjusting screws.
other signal
lines
have been correctly marked. If required,
mark again.
Check that the 4 lower fixing holes