Symbols; Product Description; Safety Information - SKYLOTEC D-BOLT AP-058 Instrucciones De Uso

1.

SYMBOLS

The system's components have pictograms, which have the following meanings:
2.

PRODUCT DESCRIPTION

The products D-Bolt AP-058, AP-063-GE-063 and AP-GPS are single anchorage points of general Building
Approval Z-14.9-704. In addition, the single anchorage point in accordance with DIN EN 795 / A are: 2012;
CEN / TS 16415 checked. The single anchorage points AP-058, AP-063-GE-063 and AP-GPS are designed
For mounting in concrete or steel and are to secure max. 3 persons (As shown in 5.1-5.3).
The single anchorage points AP-US-058, AP-US-063-GE-063 and AP-US-GPS are tested to ANSI Z359.1-2007
and are for mounting on steel and for securing (depending on version) for AP-US-058 and AP-US-063-GPS of max.
1 person (As shown in 5.4) AP-US-063-GE for max. 2 Persons.
The product was tested as a system and may only be installed using the approved fasteners described. The
anchorage point is suitable for fall protection of persons or a weight of 500 KG / 1100 lbs. The anchor point must
always be used only for intended use, either as a fall protection or as lifting, never both simultaneously.
Therefore, the individual anchoring point is particularly suitable for safely working on high buildings and for the
"Rope Access Work".
Depending on design, the materials are not resistant under extremely aggressive conditions such as e.g.
constant, alternating immersion into sea water or within proximity of sea water spray, chlorinated
atmospheres in indoor pools, or atmospheres extremely polluted with chemicals.
If the installation instructions or operating manual as well as the approval of the single anchor point are not
observed, any liability of SKYLOTEC GmbH shall be excluded.
3.

SAFETY INFORMATION

Prior to fitting, all fitters or users must read these instructions. The assembly instructions must be strictly observed
as failure to do so may endanger lives. Immediately cease fitting work for the fall-arrester device if, during this,
difficulties are encountered. More information can be obtained from the manufacturer.
MAT-MA-0005-EN_D-BOLT
Please read the operating instructions before use!
Also, please read the provided "General User Guide" by Skylotec before use!
Number of simultaneous users of this anchor point (in this example max. 3
people). As shown in 5.1-5.4.
Danger! or check equipment.
Ensure that the supplied operating instructions are stored with the equipment of the
individual anchoring point in a dry place and are accessible to all users at any time.
Before and during use, a visual check of the operability of the system must
be performed.
Attention must be paid to current sources as the anchor point
Electrically is conducting.
When installing the anchor point, take notice of the application of force in the existing
structure according to the following standards or approvals:
DIN EN 4426, EN 795:2012, ANSI Z359.1: 2007 and / or the general building approval
with the number Z-14-9-704.
09/06/2017 Page 2 of 18