Changing Oven Light - Sears Kenmore 790.79992 Manual Del Usuario

Figure 2
To Replace Oven Door:
1, Be sure the hinge arms are in the quarter-open position Be careful if pulling
the hinges open by hand, The hinges may snap back against the oven frame
and could pinch fingers,
2, Hold the door at the sides near the top., Insert the hinge arms into slots at the
bottom of the door.
3. Hinge arms must go into the range slots evenly° The hinge arms should be
inserted into the bottom corners of the door as far as they can go,
4 If the door is not in line with the oven frame, remove it and repeat the above
steps.
Changing Oven Light
(some models)
_'!_ Be sure the range is unplugged and all parts are COOL before
replacing the surface or oven lights Wear a leather-faced glove for protection
against possible broken glass,
"' " .............. / ]'i]'ii
On some models, the oven light automatically turns on when the door is
,.,b,-,_=
opened. Some models have a switch located on the control panel to turn on the !i_'i_
light, The oven light is located at the rear of the oven and is covered with a i_ ......
t]_E
glass shield held by a wire holder, The glass shield mist be in place whenever _: ; :i
the oven is in use i,i_;_
To replace the oven light:
1 Turn electrical power off at the main source or unplug the range,,
2 Press wire holder to one side to release the glass shield
3 Replace bulb with a new 40 watt appliance bulb,
4 Replace glass shield over bulb and snap wire holder into place,
5. Turn power back on again at the main source (or plug the range back in),
6. The clock(if equipped) will then need to be reset, To reset, see Setting the
Clock and Minute Timer in this Owner's Guide,,
Note: The adjustments made will not change the self-cleaning temperature.
The temperature in the oven has been set at the factory When first using the oven, be sure to follow recipe times and
temperatures. If you think the oven is too hot or too cool, the temperature in the oven can be adjusted Before adjusting,
test a recipe by using a temperature setting that is higher or lower than the recommended temperature The baking results
should help you to decide how much of an adjustment is needed,
To Adjust Oven Temperature:
1, Push _.
2 Setthe temperature to 550°F (287°C) by pushing and holding the @.
3, Within 2 seconds, push and hold (_ until the special 2 digit display appears Release _. The display now
indicates the amount of degrees offset between the original factory temperature setting and the current temperature
setting if the oven control has the original factory calibration, the display will read "00"
4, The temperature can now be adjusted up or down 35°F (17°C), in 5°F (1°C) steps, by pushing and holding the (_ or
Adjust until the desired amount of offset appears in the display., When lowering the oven temperature, a minus
sign (-) will appear before the number to indicate that the oven will be cooler by the displayed amount of degrees.
5. When you have made the desired adjustment, push _ to go back to the time of day display,
19