Oven Vent(S) And Racks; Changing Oven Light - Sears Kenmore 790.46992 Manual De Uso Y Cuidado

Surface
Cooking
FEATURE OVERVIEW
• Ceramic_GlassCooktop
Expandable Radiant Element
Control Dial
EXPANDABLE RADIANT HEATING UNITS (some models)
This heating unit adapts to both small and large heating utensils. The unit control dial has a
dual set of graduations. For small utensils use the left side of the control dial; for large utensils
the right. Only the inner surface of the unit heats when using it for small utensils; the whole
surface heats for large utensils. The hot surface and surface indicator lights will glow when the
heating unit isturned ON.
Note: During any heat setting of the outer radiant element, the inner radiant element cycles on
and off with the outer element.
Indicator Lights
Two different surface control lights will glow on your range: Surface Indicator Lights and Hot
Surface Indicator Lights.
• The surface indicator lights, located on the control panel, glow when any surface unit
is turned on. A quick glance at the lights after cooking is an easy check to be sure all
surface controls are turned off.
• The hot surface indicators lights, located under the glass cooktop, will come on as the
surface cooking area heats up and will continue to glow until the glass cooktop has cooled
down to a moderate level. The lights may remain on even though the controls are turned to
OFR
Oven Vent(s)
and Racks
Oven Vent(s) and Racks
Oven Vent Location
The oven is vented at the rear of the cooktop. When the oven is on, warm air is released
through the vent(s). This venting is necessary for proper air circulation in the oven and good
baking results. DO NOT block the vent(s). Doing so may cause cooking failures, fire or damage
to the appliance.
Arranging Oven Racks
ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIORTO OPERATING THE
OVEN). Always use oven mitts when using the oven.
To remove an oven rack, pull the rack forward until it stops. Lift up front of rack and slide out.
To replace an oven rack, fit the rack onto the guides on the oven walls. Tilt the front of the
rack upward and slide the rack back into place.
Changing Oven
Light
Be sure the oven is unplugged and all parts are COOL before replacing the oven
light bulb. Do not turn the oven light on during a self-cleaning cycle. High temperature will
reduce lamp life.
On some models an interior oven light will turn on automatically when the oven is opened.
The oven light may be turned on when the door is closed by using the oven light switch located
on the Electronic Oven control.
On a self-cleanning oven the lamp is covered with a glass shield held in place by a wire holder.
THIS GLASS SHIELD MUST ALWAYS BE IN PLACEWHEN THE OVEN IS IN USE.
To Replace the Light Bulb:
BE SUREOVEN IS COOL
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with a 40 Watt appliance bulb only.
4. For self-cleaning oven, press wire holder to one side to release glass shield, change bulb and
be sure to replace glass shield.
12