Bosch GLR500 Instrucciones De Funcionamiento Y Seguridad página 12

Volume Measurement
For volume measurements, push button 4 until
the indicator for volume measurement
appears on the display.
Afterwards, measure the length,
width and the height, one after
another, in the same manner as
for a length measurement. The
laser beam remains switched
on between all three
measurements.
After taking the third measurement, the volume is
automatically calculated and displayed in the
result line c.
The individual measured values are displayed in
the measured-value lines a.
Values above 999999 m
"ERROR" and "––––" appear on the display.
Divide the volume to be measured into individual
measurements; their values can then be calculat-
ed separately and then summarized.
Indirect Length Measurement
(see figures H–K)
The indirect length measurement is used to
measure distances that cannot be measured
directly because an obstacle would obstruct the
laser beam or no target surface is available as a
reflector. Correct results are achieved only when
the laser beam and the sought distance form an
exact right angle (90°) (Pythagorean Theorem)
Pay attention that the reference point of the
measurement (e.g. the rear edge of the
rangefinder) is at the exact same location for all
individual measurements within a measuring
sequence (exception: trapezoid measurements).
The laser beam remains switched on between the
individual measurements.
For indirect length measurements, four measuring
modes are available. Each measuring mode can
be used for determining different distances.
To select the measuring mode, push the function-
mode button 3 until the symbol of the desired
measuring mode is indicated on the display.
a) Simple Indirect Length Measurement
(see figure H)
Push the function-mode button 3 until the
indication for simple indirect length measurement
appears on the display.
2
1
Measure distances "1" and "2" in this sequence
with a length measurement. Pay attention that the
line segment "1" and the sought distance "E" form
a right angle.
3 3
/ft cannot be indicated;
b) Double Indirect Length Measurement
(see figure I)
Push the function-mode button 3 until the
indication for double indirect length measurement
appears on the display.
1
2 3
Measure distances "1", "2" and "3" in this
sequence with a length measurement. Pay
attention that the line segment "1" and the sought
distance "E" form a right angle.
c) Combined Indirect Length Measurement
(see figure J)
Push the function-mode button 3 until the
indication for combined indirect length measure-
ment appears on the display.
3
2
1
Measure distances "1", "2" and "3" in this
sequence with a length measurement. Pay
attention that the line segment "1" and the
segment sought distance "E" form a right angle.
d) Trapezoid Measurement
(see figure K)
Push the function-mode button 3 until the
indication for trapezium measurement
appears on the display.
Measure distances "1", "2" and "3" in this
sequence with a length measurement. Pay
attention that the measurement of distance "3"
starts exactly at the end point of distance "1" and
that a right angle exists between distances "1"
and "2" as well as between "1" and "3".
-12-
After taking the last measur-
ement, the result for the sought
distance "E" is displayed in the
result line c. The individual
measured values are displayed
in the measured-value lines a.
After taking the last
measurement, the result for the
sought distance "E" is displayed
in the result line c.
The individual measured values
are displayed in the
measured-value lines a.
After taking the last measure-
ment, the result for the sought
distance "E" is displayed in the
result line c.
The individual measured values
are displayed in the
measured-value lines a.
After taking the last measur-
ement, the result for the sought
distance "E" is displayed in the
result line c.
3
2
1